HomeX X1 (AK1708m-16)

From postmarketOS
(Redirected from Home x x1 (AK1708m-16))


HomeX X1
HomeX X1
HomeX X1
Manufacturer HomeX
Name X1
Codename AK1708m-16
Released 20XX
Category testing
Pre-built images no
Original software Android (TV)
Original version 6.0.1 (Linux 3.14.29)
Hardware
Chipset Amlogic S905X
CPU Quad-core 1.5 GHz Cortex-A53
GPU Mali-450 MP3
Display HDMI
Storage 8 GB
Memory 1 GB
Architecture AArch64
Type set-top box
This device is marked as not booting.
Status: non-bootable
Features
USB Networking
Flashing
Display
WiFi
FDE
Mainline
3D Acceleration
Audio
Bluetooth
Internal storage
USB OTG
Sensors
Power Sensor
Misc
Built-in DVB
Camera Flash
HDMI/DP
Ir TX
Ir RX
Stylus
Memory Card
Haptics
Ethernet
FOSS bootloader
Broken


Contributors

Users owning this device

  • Exkc (Notes: Toy found in store (dead))


Device Info

The exact model of it is unknown. Searching for the HomeX X1 online will only get you info about the X1 Ultra. However, the X1 Ultra seems to be different from the X1 in appearance, so this one might not be the X1 Ultra. From searching online, the X1 Ultra and the X1 seem to share a CPU.

The code name is from a sticker on the back side of its PCB.

How to enter flash mode

Installation

How to enter flash mode

1. Unplug the power

2. Connect the OTG-labelled port to a PC via a USB A-to-A cable.

Icon WARNING: Make sure the 5V VCC pin isn't connected, otherwise it might burn when you plug the cable in.

3. Hold the button labelled "update" (there are two, hold either one) while it powers on.


JTAG

To get JTAG working, solder wires to the JTAG points labelled on the front side of the PCB. (see File:Front pcb of Home x x1.jpeg)

UART

The baud rate is 115200. To get UART working, solder wires to the UART points labelled on the back side of the PCB. (see File:Back of Home x x1 pcb.jpeg)

Pictures

See also