Jump to content

Xiaomi POCO F3 (xiaomi-alioth): Difference between revisions

From postmarketOS Wiki
Knuxify (talk | contribs)
m adjust to new chipset naming rules (https://gitlab.com/postmarketOS/wiki/-/issues/69)
Jenneron (talk | contribs)
move to non-booting
Line 38: Line 38:
| status_otg = <!-- USB-OTG adapters work, e.g. to connect an USB flash drive to the device -->
| status_otg = <!-- USB-OTG adapters work, e.g. to connect an USB flash drive to the device -->
| status_nfc = <!-- Near-Field Communication (NFC) works -->
| status_nfc = <!-- Near-Field Communication (NFC) works -->
| booting = yes <!-- The device is booting at all, can be yes/no *IMPORTANT* -->
| booting = no <!-- The device is booting at all, can be yes/no *IMPORTANT* -->


<!-- you can also use these lines if you need to:
<!-- you can also use these lines if you need to:

Revision as of 18:36, 17 November 2022


This device is marked as not booting.
Xiaomi Poco F3
Official image for the smartphone
Official image for the smartphone
Manufacturer Xiaomi
Name Poco F3
Codename xiaomi-alioth
Released 2021
Hardware
Chipset Qualcomm Snapdragon 870 5G (SM8250-AC)
CPU Octa-core (1x3.2 GHz Kryo 585 & 3x2.42 GHz Kryo 585 & 4x1.80 GHz Kryo 585)
GPU Adreno 650
Display 1080x2400 AMOLED, 120Hz, HDR10+, 1300 nits (peak)
Storage 128/256 GB UFS 3.1
Memory 6/8 GB RAM
Architecture aarch64
Software
Original software Android 11
postmarketOS
Category testing
Pre-built images no
Mainline partial


Contributors

  • RodoMa92
  • Weijia

Maintainer(s)

Users owning this device


How to enter flash mode

Volume down + power to enter fastboot mode, volume up + power to enter recovery mode.

Installation

Flash LineageOS once, then follow the installation guide.

It is recommended to flash to the userdata partition instead of super:

$ pmbootstrap flasher flash_rootfs --partition userdata

Serial UART

TX is easily accessible, red wire on photo. RX is under a metal shield on the other side of the board. UART TX is below the sub board connector on the left size of a 0402 capacitor. Baud - 115200. For ground you can use the metal shielding.

See also