Samsung Galaxy Grand Prime Plus (samsung-grandpplte): Difference between revisions
Appearance
Change status |
Added info about UART. |
||
Line 64: | Line 64: | ||
== How to enter flash mode == | == How to enter flash mode == | ||
While turned off, hold Power+Home+Volume Down, then a menu will appear. Press Volume Up to proceed to flash mode. | While turned off, hold Power+Home+Volume Down, then a menu will appear. Press Volume Up to proceed to flash mode. | ||
== UART == | |||
Accessing UART is possible through the microUSB port by putting a 619kΩ resistor between the ID pin and ground. Read [[Serial debugging]] for more on that. Currently only bootloader logs can be read through UART during the initial boot process. | |||
<!-- == Installation == add more sections below as necessary, e.g. WiFi, photos, ... --> | <!-- == Installation == add more sections below as necessary, e.g. WiFi, photos, ... --> |
Revision as of 12:04, 17 December 2020
WARNING: This device cannot run postmarketOS, as its architecture is unsupported. |
This device is marked as not booting.
CHANGE_ME CHANGE_ME | |
Manufacturer | Samsung |
---|---|
Name | Galaxy Grand Prime+ |
Codename | samsung-grandpplte |
Released | 2016 |
Hardware | |
Chipset | MediaTek MT6737T |
CPU | 4x 1.4 GHz Cortex-A53 |
GPU | Mali-T720MP2 |
Display | 960x540 LCD |
Storage | 8 GB |
Memory | 1.5 GB |
Architecture | armv7 (cpu is aarch64, but oem software is armv7) |
Software | |
Original software | Android 6.0.1 |
postmarketOS | |
Category | testing |
Pre-built images | no |
Mainline | no |
Contributors
- Tooniis
Maintainer(s)
Users owning this device
- Tooniis (Notes: SM-G532F)
How to enter flash mode
While turned off, hold Power+Home+Volume Down, then a menu will appear. Press Volume Up to proceed to flash mode.
UART
Accessing UART is possible through the microUSB port by putting a 619kΩ resistor between the ID pin and ground. Read Serial debugging for more on that. Currently only bootloader logs can be read through UART during the initial boot process.
Status
Downstream kernel does not want to compile yet.
Mainline
MT6737T (based on MT6735) is not mainlined, so mainlining this device will also require mainlining its SoC.