Jump to content

Samsung Galaxy Grand Prime Plus (samsung-grandpplte): Difference between revisions

From postmarketOS Wiki
Tooniis (talk | contribs)
Added image
Tooniis (talk | contribs)
Added baud rate
Line 66: Line 66:


== UART ==
== UART ==
Accessing UART is possible through the microUSB port by putting a 619kΩ resistor between the ID pin and ground. Read [[Serial debugging]] for more on that. Currently only bootloader logs can be read through UART during the initial boot process.
Accessing UART is possible through the microUSB port by putting a 619kΩ resistor between the ID pin and ground. Read [[Serial debugging]] for more on that. Currently only bootloader logs can be read through UART during the initial boot process. Baud rate is 115200.


<!-- == Installation ==  add more sections below as necessary, e.g. WiFi, photos, ... -->
<!-- == Installation ==  add more sections below as necessary, e.g. WiFi, photos, ... -->

Revision as of 15:36, 17 December 2020

Warning WARNING: This device cannot run postmarketOS, as its architecture is unsupported.
This device is marked as not booting.
Samsung Galaxy Grand Prime+
Grand Prime+ running stock Android
Grand Prime+ running stock Android
Manufacturer Samsung
Name Galaxy Grand Prime+
Codename samsung-grandpplte
Released 2016
Hardware
Chipset MediaTek MT6737T
CPU 4x 1.4 GHz Cortex-A53
GPU Mali-T720MP2
Display 960x540 LCD
Storage 8 GB
Memory 1.5 GB
Architecture armv7 (cpu is aarch64, but oem software is armv7)
Software
Original software Android 6.0.1
postmarketOS
Category testing
Pre-built images no
Mainline no


Contributors

  • Tooniis

Maintainer(s)

Users owning this device


How to enter flash mode

While turned off, hold Power+Home+Volume Down, then a menu will appear. Press Volume Up to proceed to flash mode.

UART

Accessing UART is possible through the microUSB port by putting a 619kΩ resistor between the ID pin and ground. Read Serial debugging for more on that. Currently only bootloader logs can be read through UART during the initial boot process. Baud rate is 115200.

Status

Downstream kernel does not want to compile yet.

Mainline

MT6737T (based on MT6735) is not mainlined, so mainlining this device will also require mainlining its SoC.

See also