Purism Librem5 (purism-librem5): Difference between revisions
Appearance
m URL previously linked to for preparing the phone for flashing is for non-evergreen devices, I think. Somehow the official documentation "regressed". |
mNo edit summary |
||
Line 34: | Line 34: | ||
| status_mobiledata = Y | | status_mobiledata = Y | ||
| status_sms = Y | | status_sms = Y | ||
| status_calls = | | status_calls = Y | ||
| status_otg = P | | status_otg = P | ||
| booting = Y | | booting = Y |
Revision as of 08:51, 17 February 2021
Template:Note-device-milestone-main
![]() | |
Manufacturer | Purism |
---|---|
Name | Librem 5 |
Codename | purism-librem5 |
Released | 2019 |
Hardware | |
Chipset | Emcraft NXP i.MX8M |
CPU | 4x 1.5 GHz Cortex-A53 |
GPU | Vivante GC7000Lite |
Display | 1440x720 |
Storage | 32 GB eMMC |
Memory | 3 GB |
Architecture | aarch64 |
Software | |
Original software | PureOS |
postmarketOS | |
Category | community |
Pre-built images | yes |
Flashing |
Works |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
Works |
Screen |
Works |
Touchscreen |
Works |
Multimedia | |
3D Acceleration |
Works |
Audio |
Works |
Camera |
No data |
Camera Flash |
No data |
Connectivity | |
WiFi |
Works |
Bluetooth |
Works |
GPS |
Works |
NFC |
No data |
Modem | |
Calls |
Works |
SMS |
Works |
Mobile data |
Works |
Miscellaneous | |
FDE |
Works |
USB OTG |
Partial |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
Works |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
Installation
Flashing
Old method
To put the phone into flash mode, unplug charging cable, remove battery, hold the Vol+ button and then re-insert battery and plug in USB cable to computer. pmOS can be flashed to the device by executing pmbootstrap flasher flash_rootfs
Evergreen Batch Method
Prepare the phone by following the steps at: https://source.puri.sm/Librem5/developer.puri.sm/-/blob/ed09a5d1f7701a7312de8b1277ff14115ec6bf03/Development_Environment/Phone/Troubleshooting/Reflashing_the_Phone.rst
Make sure you have initialized and installed a flashable image using pmbootstrap [1].
Finally, in a terminal, run: pmbootstrap flasher flash_rootfs
Known Issues
For an ever-up-to-date list of issues, see gitlab
- Suspend, as implemented in gnome settings under phosh, is not supported by the device [2].
Related
- pmaports!1673 upgrade to 5.9.1, information about selecting dtb on boot with u-boot (not enabled in this MR yet)