Xunlong Orange Pi 3 (xunlong-orangepi3): Difference between revisions
Update Ethernet status |
Update ethernet status |
||
Line 74: | Line 74: | ||
== Ethernet == | == Ethernet == | ||
Main blocker is described [https://gitlab.com/postmarketOS/pmaports/-/merge_requests/2487 here]. Until it's resolved, you'll have to pick that patch and build u-boot manually, than flash it manually over an existing pmOS installation, out of scope of this page. | |||
== See also == | == See also == |
Revision as of 19:00, 21 September 2021
![]() Orange Pi 3 with UART connected | |
Manufacturer | Xunlong |
---|---|
Name | Orange Pi 3 |
Codename | xunlong-orangepi3 |
Released | 2019 |
Hardware | |
Chipset | Allwinner H6 |
CPU | 4x 1.8 GHz ARM Cortex-A53 |
GPU | Mali T720 MP2 600 MHz |
Display | HDMI port |
Storage | 8 GB eMMC (or empty slot) + microSD |
Memory | 1/2 GiB |
Architecture | aarch64 |
Software | |
Original software | BSP Linux 4.9 |
postmarketOS | |
Category | testing |
Pre-built images | no |
Mainline | yes |
postmarketOS kernel | Mainline |
Unixbench Whet/Dhry score | 1455.9 |
USB Networking |
Works |
---|---|
Internal storage |
No data |
SD card |
No data |
Screen |
Works |
Multimedia | |
3D Acceleration |
Works |
Audio |
Partial |
Camera Flash |
No data |
Connectivity | |
WiFi |
Works |
Bluetooth |
Works |
Miscellaneous | |
FDE |
No data |
USB OTG |
Works |
HDMI/DP |
No data |
Sensors | |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
Maintainer(s)
Users owning this device
- Exkc (Notes: toy found in store (no power brick))
Installation
Follow the Installation_guide, use sdcard method. Then insert microSD into TF-card slot and plug the power cable, pmOS should boot. If not, try once again (on cold boot SPL sometimes decides there is 4096 MiB of RAM and boot hangs).
To install to eMMC, flash ondev to SD or run pmbootstrap from present pmOS installation on SD.
Serial console
See linux-sunxi wiki page, connect your USB-UART adapter's RX to board's TX and vice versa.
OTG
As said in board's DTS,
/*
* This board doesn't have a controllable VBUS even though it
* does have an ID pin. Using it as anything but a USB host is
* unsafe.
*/
So you can't connect it to a PC via microUSB to transfer data, it will only gain charge. But there is 5 standard USB ports that can be used to connect any devices.
Audio
Hardware codec isn't supported in Linux kernel yet, so audio jack output won't work. However, HDMI audio works.
Ethernet
Main blocker is described here. Until it's resolved, you'll have to pick that patch and build u-boot manually, than flash it manually over an existing pmOS installation, out of scope of this page.
See also
- linux-sunxi wiki page
- pmaports!2268 Initial merge request