Xiaomi Redmi Note 5A: Difference between revisions
m Tested audio support |
|||
Line 68: | Line 68: | ||
== How to enter flash mode == | == How to enter flash mode == | ||
While the phone is off, hold the Power | While the phone is off, hold the {{Button|Power}} + {{Button|Volume Down}} buttons together for a few seconds. | ||
== How to enter EDL mode == | == How to enter EDL mode == |
Revision as of 11:33, 28 May 2023
![]() Xiaomi Redmi Note 5A running XFCE4 | |
Manufacturer | Xiaomi |
---|---|
Name | Redmi Note 5A |
Codename | xiaomi-ugg |
Released | 2017 |
Hardware | |
Chipset | Qualcomm Snapdragon 435 (MSM8940) |
CPU | 1.4 GHz Cortex-A53 |
GPU | Adreno 505 |
Display | 720x1280 IPS LCD |
Storage | 32G |
Memory | 3GB |
Architecture | aarch64 |
Software | |
Original software | Android 7.1.2, MIUI 11 |
FOSS bootloader | no |
postmarketOS | |
Category | testing |
Pre-built images | no |
Flashing |
Works |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
Works |
Screen |
Partial |
Touchscreen |
Works |
Multimedia | |
3D Acceleration |
No data |
Audio |
Broken |
Camera |
No data |
Camera Flash |
No data |
IR TX |
No data |
Connectivity | |
WiFi |
No data |
Bluetooth |
No data |
GPS |
No data |
Modem | |
Calls |
No data |
SMS |
No data |
Mobile data |
No data |
Miscellaneous | |
FDE |
No data |
USB OTG |
No data |
Sensors | |
Accelerometer |
No data |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Power Sensor |
No data |
Contributors
- Flafflar
Users owning this device
- Bczeman
- Filip2cz (Notes: Prime version - this just added fingerprint reader, better camera and littlebit better cpu)
- Flafflar (Notes: Broken camera)
- Xiaoyu2006 (Notes: Broken display)
How to enter flash mode
While the phone is off, hold the
+ buttons together for a few seconds.How to enter EDL mode
EDL mode (Emergency Download Mode) is a special mode in Qualcomm devices that allows, among other things, flashing firmware even when the phone is completely bricked. This might come useful in case something goes extremely wrong and the device won't even boot to fastboot.
To boot into EDL, you must first disassemble the device in order to expose the motherboard points required. This phone is very easy to disassemble, you can search for videos on YouTube if necessary. Once you have removed the back case and disconnected the battery, find the points shown below on the motherboard:
These are the test points that enable EDL mode. With the battery disconnected, use a metal tweezer or a small wire to short these two points. While keeping them sorted, plug the phone to a computer. The device should show up as "Qualcomm HS-USB QDLoader 9008". You can now use this tool to download firmware to your device.