Jump to content

Xiaomi POCO F3 (xiaomi-alioth): Difference between revisions

From postmarketOS Wiki
m Fix dead chipset link
Line 63: Line 63:
<!-- you may need to purge page cache to see changes (more->purge cache)-->
<!-- you may need to purge page cache to see changes (more->purge cache)-->
<!-- you can use {{My devices}} on your profile page to show table with all your devices -->
<!-- you can use {{My devices}} on your profile page to show table with all your devices -->
{{Owns device|Xiaomi_Poco_F3_(xiaomi-alioth)|Trying to install pmOS}}


== How to enter flash mode ==
== How to enter flash mode ==

Revision as of 13:42, 21 January 2025


Xiaomi POCO F3
Official image for the smartphone
Official image for the smartphone
Manufacturer Xiaomi
Name POCO F3
Codename xiaomi-alioth
Released 2021
Type handset
Hardware
Chipset Qualcomm Snapdragon 870 (SM8250-AC)
CPU Octa-core (1x3.2 GHz Kryo 585 & 3x2.42 GHz Kryo 585 & 4x1.80 GHz Kryo 585)
GPU Adreno 650
Display 1080x2400 AMOLED, 120Hz, HDR10+, 1300 nits (peak)
Storage 128/256 GB UFS 3.1
Memory 6/8 GB RAM
Architecture aarch64
Software
Original software Android
Original version 11
postmarketOS
Category testing
Pre-built images no
Mainline partial
Features
Flashing
Works
USB Networking
Works
Internal storage
No data
SD card
No data
Battery
No data
Screen
Works
Touchscreen
Works
Multimedia
3D Acceleration
No data
Audio
No data
Camera
No data
Camera Flash
No data
Connectivity
WiFi
Broken
Bluetooth
No data
GPS
No data
NFC
No data
Modem
Calls
No data
SMS
No data
Mobile data
No data
Miscellaneous
FDE
No data
USB OTG
No data
HDMI/DP
No data
Sensors
Accelerometer
No data
Magnetometer
No data
Ambient Light
No data
Proximity
No data
Hall Effect
No data
Haptics
No data
Barometer
No data


Contributors

  • RodoMa92
  • Weijia

Maintainer(s)

Users owning this device


How to enter flash mode

Volume down + power to enter fastboot mode, volume up + power to enter recovery mode.

Installation

Flash LineageOS once, then follow the installation guide.

It is recommended to flash to the userdata partition instead of super:

$ pmbootstrap flasher flash_rootfs --partition userdata

Serial UART

UART TX is below the sub board connector on the left size of a 0402 capacitor. Baud - 115200. For ground you can use the metal shielding.

TX is easily accessible, red wire on photo. RX is under a metal shield on the other side of the board.


See also