Jump to content

Motorola Moto E4 (motorola-perry)

From postmarketOS Wiki
Revision as of 21:20, 28 April 2020 by Lastramses (talk | contribs) (Installation: update formatting and add content)
Motorola Moto E4
xfce4 running on Moto E4
xfce4 running on Moto E4
Manufacturer Motorola
Name Moto E4
Codename motorola-perry
Released 2017
Hardware
Chipset Qualcomm MSM8920 Snapdragon 427
CPU 4x 1.4 GHz Cortex-A53
GPU Adreno 308
Display 720x1280 IPS LCD
Storage 16 GB
Memory 2 GB
Architecture aarch64
Software
Original software Android 7.1
postmarketOS
Category testing
Pre-built images no
postmarketOS kernel 3.18.140
Features
Flashing
Works
USB Networking
Works
Internal storage
No data
SD card
No data
Battery
No data
Screen
Works
Touchscreen
Works
Multimedia
3D Acceleration
No data
Audio
No data
Camera
No data
Camera Flash
No data
Connectivity
WiFi
Works
Bluetooth
No data
GPS
No data
NFC
No data
Modem
Calls
No data
SMS
No data
Mobile data
No data
Miscellaneous
FDE
No data
USB OTG
Works
HDMI/DP
No data
Sensors
Accelerometer
No data
Magnetometer
No data
Ambient Light
No data
Proximity
No data
Hall Effect
No data
Haptics
No data
Barometer
No data


Contributors

  • lastramses

Maintainer(s)

Users owning this device


How to enter flash mode

hold Power On and Volume Down buttons while device is powered off.

The device has to be unlocked before images can be replaced. It is strongly suggested to use TWRP recovery (twrp-perry-3.2.1-r1.img verified to work) if debugging is necessary. If the device does not boot it is possible to access log from last attempt at sys/fs/pstore/console-ramoops via TWRP.

Installation

the port has been done on the SKU: XT1766 of the Motorola E4 (Perry) version $ pmbootstrap checksum linux-motorola-perry $ pmbootstrap kconfig check $ pmbootstrap build linux-motorola-perry $ pmbootstrap checksum firmware-motorola-perry $ pmbootstrap build firmware-motorola-perry $ pmbootstrap checksum device-motorola-perry $ pmbootstrap build device-motorola-perry $ pmbootstrap install plug the device to computer and switch it to the fastboot mode $ pmbootstrap flasher flash_kernel $ pmbootstrap flasher flash_rootfs finally run $ pmbootstrap flasher boot or reset the device

Device should boot with display and be accessible via ssh @172.16.42.1

Additional information

Normally display should work without any modification but at the time of writing there was a compatibility issue with Xorg packages (particularly Xorg-server) in the EDGE repository. To resolve the issue after flashing the phone postmarketos-ui-xfce4 and Xorg-server packages have been removed and installed from 3.11/main repository.

See also