Home x x1 (AK1708m-16)
![]() home x1 x1 | |
Manufacturer | Home x |
---|---|
Name | x1 |
Codename | AK1708m-16 |
Released | 20XX |
Category | testing |
Original software | Android TV |
Original version | 6.0.1 (Linux 3.14.29) |
Hardware | |
Chipset | Amlogic S905X |
CPU | Quad-core 1.5 GHz Cortex-A53 |
GPU | Mali-450 MP3 |
Display | HDMI |
Storage | 8 GB |
Memory | 1 GB |
Architecture | aarch64 |
Type | set-top box |
Status: non-bootable
USB Networking | |
---|---|
Flashing | |
Touchscreen |
Unavailable |
Display | |
WiFi | |
FDE | |
Mainline | |
Battery |
Unavailable |
3D Acceleration | |
Audio | |
Bluetooth | |
Camera |
Unavailable |
GPS |
Unavailable |
Mobile data |
Unavailable |
SMS |
Unavailable |
Calls |
Unavailable |
USB OTG | |
NFC |
Unavailable |
Accelerometer |
Unavailable |
---|---|
Magnetometer |
Unavailable |
Ambient Light |
Unavailable |
Proximity |
Unavailable |
Hall Effect |
Unavailable |
Barometer |
Unavailable |
Power Sensor | |
Camera Flash | |
---|---|
Keyboard |
Unavailable |
Touchpad |
Unavailable |
USB-A |
Unavailable |
HDMI/DP | |
Ir TX | |
Ir RX | |
Stylus | |
Haptics | |
Ethernet | |
FOSS bootloader |
Broken |
Contributors
Users owning this device
- Exkc (Notes: 40HKD(5.11USD) toy found in store (no power brick n remote)(dead))
Device Info
The exact model of it is unknown.It said it is x1 in the setting.If u search home x x1 online , u will only can find info about x1 ultra. However,x1 ultra seem to be different from this x1 (because they look different ) so this one might not is x1 ultra.Also, base on info from online x1 ultra seem to use the same cpu at this one.
Also the code name is from a sticker on the back side of the pcb of it.
How to enter flash mode
Installation
How to enter flash mode
0. unplug the power
1. Connect usb port that has labeled OTG to your pc via usb male a to usb male a.
WARNING: Make sure the 5v vcc pin aint connected in the cable otherwise it might will burn when u plug the cable to it. |
2. Holding the button that has labeled update (There 2 button r labeled update so press either one) while u power it on and u r done.
Jtag
To get JTAG working, solder wires the jtag points that is labeled on the front side of the pcb.(see File:Front pcb of Home x x1.jpeg)
UART
The baud rate is 115200. To get UART working, solder wires the uart points that is labeled on the back side of the pcb.(see File:Back of Home x x1 pcb.jpeg)