Difference between revisions of "Next Thing Co. CHIP (ntc-chip)"

From postmarketOS
Jump to navigation Jump to search
m
(Remove command line to rename kernel as it is done automatically)
Line 96: Line 96:
 
$ sudo mkdir chroot_rootfs_ntc-chip/boot/dtbs
 
$ sudo mkdir chroot_rootfs_ntc-chip/boot/dtbs
 
$ sudo cp cache_git/pmaports/device/testing/linux-ntc-chip/sun5i-r8-chip.dtb chroot_rootfs_ntc-chip/boot/dtbs/
 
$ sudo cp cache_git/pmaports/device/testing/linux-ntc-chip/sun5i-r8-chip.dtb chroot_rootfs_ntc-chip/boot/dtbs/
</syntaxhighlight>
 
* Rename the linux kernel
 
<syntaxhighlight lang="shell-session">
 
$ sudo cp chroot_rootfs_ntc-chip/boot/vmlinuz-ntc-chip chroot_rootfs_ntc-chip/boot/zImage
 
 
</syntaxhighlight>
 
</syntaxhighlight>
  

Revision as of 13:39, 25 March 2020

Next Thing Co. CHIP
Next Thing Co. CHIP
Next Thing Co. CHIP
Manufacturer Next Thing Co.
Name CHIP
Codename ntc-chip
Released 2015
Category testing
Original software Debian on Linux 4.4
Hardware
Chipset Allwinner R8
CPU 1x 1.0 GHz Cortex-A8
GPU Mali-400 MP1
Display Composite video
Storage 8GB MLC NAND
Memory 512 MB DDR3
Architecture armv7
Features
USB Networking
Flashing
Touchscreen
Unavailable
Display
WiFi
Xwayland
FDE
Mainline
Battery
3D Acceleration
Accelerometer
Audio
Bluetooth
Camera
Unavailable
GPS
Unavailable
Mobile data
Unavailable
SMS
Unavailable
Calls
Unavailable
USB OTG



Contributors

  • Symmetrist

Maintainer(s)

  • Symmetrist

Users owning this device


How to enter flash mode

The CHIP has two different flashing modes:

  • FEL mode: used to flash bootloader and rootfs
  • Fastboot mode: used to flash rootfs


To enter FEL mode:

  • Connect the FEL and GND pins with a jumper cable
  • Power on the CHIP

To enter Fastboot mode:

  • Connect an serial (UART) USB adapter to UART1-TX, UART1-RX and GND
  • Power on the CHIP
  • Press enter during boot up to access the U-Boot console
  • On the console type `fastboot 0`

Create the UBIfs image

  • Configure the installation
$ pmbootstrap init
  • Build the system
$ pmbootstrap install

In `workdir/chroot_rootfs_ntc-chip` there is the rootfs for your ntc-chip The following commands needs to be launched from your pmbootstrap workdir

  • Copy dtb from linux-ntc-chip
$ sudo mkdir chroot_rootfs_ntc-chip/boot/dtbs
$ sudo cp cache_git/pmaports/device/testing/linux-ntc-chip/sun5i-r8-chip.dtb chroot_rootfs_ntc-chip/boot/dtbs/

Install mtd-utils from your distro repositories e.g. `pacman -S mtd-utils`

  • Create the UBIfs image
$ mkdir ubi
$ sudo mkfs.ubifs -m 16384 -e 0x1f8000 -c 2000 -r chroot_rootfs_ntc-chip ubi/ubifs.img
$ sudo chown youruser:youruser ubi/ubifs.img
$ ubinize -o ubi/ubi.img -m 16384 -p 2MiB -s 16384 cache_git/pmaports/device/testing/device-ntc-chip/ubinize.cfg
$ img2simg ubi/ubi.img ubi/ubi.img.sparse 2097152

Flash the UBIfs image

  • Enter fastboot mode as described above
  • On your computer
$ sudo fastboot erase UBI
$ sudo fastboot flash UBI ubi/ubi.img.sparse
$ sudo fastboot reboot

See also