Nokia 8000 4G (nokia-sparkler)
Manufacturer | Nokia |
---|---|
Name | 8000 4G |
Codename | nokia-sparkler |
Released | 2020 |
Category | testing |
Original software | KaiOS |
Original version | 2.5.4 |
Hardware | |
Chipset | Qualcomm Snapdragon 210 (MSM8909) |
CPU | 4x 1.1 GHz Cortex-A7 |
GPU | Adreno 304 |
Display | 240x320 TFT |
Storage | 4 GB |
Memory | 512 MB |
Architecture | armv7 |
USB Networking |
Works |
---|---|
Flashing |
Works |
Touchscreen |
Unavailable |
Display |
Works |
WiFi |
Works |
FDE | |
Mainline |
Works |
Battery |
Works |
3D Acceleration | |
Audio | |
Bluetooth |
Works |
Camera | |
GPS | |
Mobile data |
Works |
SMS |
Works |
Calls | |
USB OTG | |
NFC | |
Accelerometer |
Unavailable |
---|---|
Magnetometer | |
Ambient Light | |
Proximity | |
Hall Effect | |
Barometer | |
Power Sensor | |
Camera Flash | |
---|---|
Keyboard | |
Touchpad | |
USB-A | |
HDMI/DP | |
Ir TX | |
Ir RX | |
Stylus | |
Haptics | |
Ethernet | |
FOSS bootloader | |
Contributors
Users owning this device
Modem
Tested with ModemManager. You might need to tweak the timeout in /etc/conf.d/msm-modem-uim-selection to get the UIM to initialize.
Mainline
This device is supported by the msm8916-mainline kernel.
lk2nd (experimental-tmp branch) works with slight modifications, see the Installation section below.
Installation
Install the lk2nd branch from https://github.com/msm8916-mainline/lk2nd/pull/214 into the boot partition. After that, you can use pmbootstrap flasher commands to flash postmarketOS via the fastboot interface provided by lk2nd.
Because this lk2nd is based on the experimental-tmp branch and does not support fs-boot yet, pmbootstrap flasher flash_kernel
is required even when booting from an SD card.
See also
- Open Source Releases - Nokia
- Board schematics - also valid for Nokia 6300 4G (nokia-leo) because the only difference seems to be the display size. Nokia 8000 4G is called "premium version" in this document