ODROID N2+ (odroid-n2plus)
Revision as of 18:06, 4 February 2023 by Vincele (talk | contribs) (→See also: forgotten this small one)
![]() odroid-n2plus runs postmarketOS | |
Manufacturer | ODROID |
---|---|
Name | N2+ |
Codename | odroid-n2plus |
Released | 2020 |
Category | testing |
Original software | Ubuntu |
Original version | 20.04 |
Optional software | Android Pie |
postmarketOS kernel | 5.14.3 |
Hardware | |
Chipset | Amlogic S922X (rev C) |
CPU | Quad-core Cortex-A73 @ 2.4GHz and Dual-core Cortex-A53 @ 2.0GHz |
GPU | Mali-G52 GPU with 6x Execution Engines @ 800MHz |
Display | none, but HDMI 2.0 connector up to 4K@60Hz with HDR, CEC, EDID |
Storage | eMMC connector (8/16/32/64/128GB) and microSD slot (DS/HS modes up to UHS-I SDR104) |
Memory | 2GB/4GB DDR4 with 32bit bus width, 2640 MT/s data rate (PC4-21333 grade), 1.2V low power design |
Architecture | aarch64 |
Unixbench Whet/Dhry score | 4142.2 |
USB Networking |
Unavailable |
---|---|
Flashing |
Unavailable |
Touchscreen |
Unavailable |
Display |
Works |
WiFi |
Unavailable |
FDE |
Unavailable |
Mainline |
Broken |
Battery |
Unavailable |
3D Acceleration | |
Audio |
Unavailable |
Bluetooth |
Unavailable |
Camera |
Unavailable |
GPS |
Unavailable |
Mobile data |
Unavailable |
SMS |
Unavailable |
Calls |
Unavailable |
USB OTG |
Unavailable |
NFC |
Unavailable |
Accelerometer |
Unavailable |
---|---|
Magnetometer | |
Ambient Light | |
Proximity | |
Hall Effect | |
Barometer | |
Power Sensor | |
Camera Flash | |
---|---|
Keyboard | |
Touchpad | |
USB-A | |
HDMI/DP | |
Ir TX | |
Ir RX | |
Stylus | |
Haptics | |
Ethernet | |
FOSS bootloader | |
Contents
Contributors
Users owning this device
How to enter flash mode
Installation
Preparation
The device uses u-boot with petitboot loader loaded in spi memory. Installation to eMMC was tested:
pmbootstrap build linux-odroid-n2plus pmbootstrap build device-odroid-n2plus
Put an eMMC card into eMMC-to-USB3 reader, assumption is it appears as /dev/sdX (replace sdX with correct devicename below), and install to it:
pmbootstrap install --sdcard /dev/sdX
Afterwards, still this manual step is needed to create u-boot compatible initramfs:
mount /dev/sdX1 /mnt/boot && \ cd /mnt/boot && \ mkimage -A arm64 -T ramdisk -C none -n initramfs -d initramfs initramfs.uimg