Prestigio MultiPad PMT5008 3G (prestigio-pmt5008-3g)
200px CHANGE_ME | |
Manufacturer | Prestigio |
---|---|
Name | Prestigio MultiPad PMT5008 3G |
Codename | prestigio-pmt5008-3g |
Released | 2016 |
Category | testing |
Original software | Android 4.4 |
Hardware | |
Chipset | MediaTek MT8382 |
CPU | 4x1.3 GHz Cortex A7 |
GPU | Mali-400 MP2 |
Display | 1280x800 IPS |
Storage | 8 GB |
Memory | 1 GB |
Architecture | armv7 |
USB Networking | |
---|---|
Flashing | |
Touchscreen | |
Display | |
WiFi | |
FDE | |
Mainline |
Partial |
Battery | |
3D Acceleration | |
Audio | |
Bluetooth | |
Camera | |
GPS | |
Mobile data | |
SMS | |
Calls | |
USB OTG | |
NFC | |
Accelerometer | |
---|---|
Magnetometer | |
Ambient Light | |
Proximity | |
Hall Effect | |
Ir TX | |
---|---|
TrustZone | |
This device is based on MediaTek MT6582. See the SoC page for common tips, guides and troubleshooting steps |
Contributors
- km2
Users owning this device
- Km2 (Notes: I'm trying to port mainline)
How to enter flash mode
Installation
Mainline Kernel Status
There is no downstream kernel source code for this device. So I decided to port mainline linux and I was pretty quick to successfully start 4 uart ports, wdt, smp and /bin/sh from initramfs. But for further progress, you need to write the pinctrl and clk drivers.
Also this device uses pmic mt6323 which seems to be in mainline.