Samsung Galaxy Ace 3 3G (samsung-logan)

From postmarketOS
Jump to navigation Jump to search
Note Not to be confused with the LTE model, which has a Qualcomm SoC! (If you have a letter after the model number, you have the LTE model.)
Samsung Galaxy Ace 3 3G
GT-S7270 running Firefox under Xfce4
GT-S7270 running Firefox under Xfce4
Manufacturer Samsung
Name Galaxy Ace 3 3G
Codename samsung-logan
Released 2013
Category testing
Original software Android
Original version 4.2.2 (Jelly Bean)
postmarketOS kernel 3.4.5
Hardware
Chipset Broadcom BCM21664
CPU 1.0 GHz Cortex-A9
GPU VideoCore IV
Display 480x800 TFT
Storage 4 GB
Memory 1 GB
Architecture armv7
Features
USB Networking
Works
Flashing
Works
Touchscreen
Works
Display
Works
WiFi
Broken
FDE
Mainline
Unavailable
Battery
Partial
3D Acceleration
Audio
Broken
Bluetooth
Broken
Camera
Broken
GPS
Broken
Mobile data
SMS
Calls
USB OTG
NFC
Unavailable
Sensors
Accelerometer
Magnetometer
Ambient Light
Proximity
Hall Effect
Barometer
Power Sensor
Misc
Camera Flash
Keyboard
Unavailable
Touchpad
Unavailable
USB-A
Unavailable
HDMI/DP
Unavailable
Ir TX
Unavailable
Ir RX
Stylus
Haptics
Ethernet
FOSS bootloader
Broken



Contributors

Users owning this device

  • AppData 174 (Notes: 7270, SD card slot is probably broken)

How to enter flash mode

  • Download mode: While the device is turned off, hold Power + Home + Volume Down, and confirm the action by pressing Volume Up thereafter.
  • Recovery mode: While the device is turned off, hold Power + Home + Volume Up.

Installation

pmbootstrap init # Choose samsung-logan
pmbootstrap install
# Boot into download mode before running the command below
pmbootstrap flasher flash_rootfs
# Boot into download mode again
pmbootstrap flasher flash_kernel

Hardware Acceleration

Note Note: This is not fully tested and could not work.
  1. Open aports/device/testing/device-samsung-logan/APKBUILD in a text editor and add mesa-egl to the depends
  2. Rebuild the device package: pmbootstrap build device-samsung-logan --force
  3. Run pmbootstrap install --fde

However, the image will be much bigger than the system partition, so you will need to either flash it to another partition or an SD card.

USB Internet

See USB Internet.

Display

If your device is stuck on the postmarketOS splash screen on startup (or the screen is black) and you are using LightDM, connect to your phone via SSH and run this command:

loginctl show-seat seat0

If CanGraphical is no or 0, open the LightDM config in a text editor:

sudo vi /etc/lightdm/lightdm.conf

Find the line where it says #logind-check-graphical=true and replace it with logind-check-graphical=false. Restart the device and it now should work.

See also

  • pmaports!3779 Initial merge request (Not merged at the time of writing)