Samsung Galaxy Ace II X (samsung-kylessopen)
The Samsung Galaxy Ace II X (GT-S7560M) is also sold as the Samsung Galaxy Trend (GT-S7560).
- 1 Installation
- 2 In Progress
- 3 Hardware
Before installing, ensure that your host computer and your copy of pmbootstrap is fully up to date and that your system has been rebooted since it was last updated.
$ ./pmbootstrap.py init
Select "samsung-kylessopen" as the target device and select a working recommended graphical interface.
$ ./pmbootstrap.py install --no-fde
See the 'in progress' section regarding full disk encryption.
flashEnsure that the USB cable is disconnected, then hold down + for a few seconds as the system boots. This puts the device in flash mode. Once in this mode, enter
$ ./pmbootstrap.py flasher flash_rootfs
$ ./pmbootstrap.py flasher flash_kernel
Here is a list of tasks that are currently being worked on for this device, from highest priority to lowest.
Mainlining is an important task for this device, because kernels and drivers that supposedly work for this device are scattered across various git repositories, usually forks of other projects, often heavily patched and abandoned. Relying on kernels that can have their repos deleted at any moment, that are often heavily fractured anyways probably isn't a good idea.
All of these kernels claim to be for this device however, it's not known which of these kernels actually work and how well they work. FrankenKernel is the only exception as it is the kernel that gets flashed when installing this device. See Troubleshooting:boot.
Device regularly reboots itself
This is almost certainly a watchdog issue, since the device reboots every 10 minutes. I'm currently working on disabling the watchdog. pmaports#242
The internet works fine using USB_Internet however, thee are no interfaces shown that allow WiFi. This seems to be caused by the lack of the linux-firmware-ath6k firmware but even when loading it, it doesn't work. A kernel patch is likely necessary. See pmaports#248.
Device sometimes freezes while booting
Nothing is known about this issue yet.
FDE doesn't work
FDE doesn't work at the current moment. See FBDirect issue.
Error starting charging-sdl
bluetoothctl doesn't do anything when run. It's suspected to be due to the firmware not being installed. See pmaports#248.
Scrolling graphics before DE
Before a desktop environment starts, the screen tends to flicker and scroll. It's a purely cosmetic issue. It's cause is likely related to the framebuffer and may be similar in nature to the FBDirect issue.