Open main menu


no edit summary
| display = 1280x800
| memory = 1 GB
| architecture = armhfarmv7
| status_usbnet = Y
| status_flashing = P
| status_xwayland =
| status_fde = Y
| status_mainline = NP| status_battery = PY
| status_3d = N
| status_accel =
== Contributors ==
* WilliamO7
* Archbtw
== Maintainer(s) ==
* Wifi (if started up manually, there's still some problems on boot)
* FDE w/ [[osk-sdl]]* Battery (Gnome 3 can read the battery percentage and , whether it is discharging or charging, but and [[Charging-sdl]] does work. One small issue is that Gnome 3 cannot estimate detect the battery time remaining)
== What does not work ==
* RIL (hasn't been setup yet, but Replicant got it going on the android side so it should be possible.)
* 2D + 3D acceleration (so most UIs slow down to a crawl, such as plasma-mobile). With a mainlined kernel this should be possible.
* Currently the kernel is not mainlined, but the [[Texas_Instruments_OMAP_4_(OMAP44xx)|OMAP chip is supported]], so it should be possible to mainline.
* Bluetooth service crashes; Running <code>sudo service bluetooth start</code> and then <code>sudo service bluetooth status</code> returns "crashed"
== Installation ==
This has to be done in two parts:
* First create an [[Android Recovery Zip Installation|Android recovery image]] of PMOS and flash it using TWRP. If it refuses to flash using the "Install" option, try to flash it with adb sideload.
* Then use the usual heimdall flasher method to install the kernel and initramfs (flash_kernel).
Doing both with one method results in errors in both situations.
Note: If you wish to install to the /data partition instead of the system partition, extract the Android recovery image, replace FACTORYFS with DATAFS in chroot/install_options, and re-archive it with no compression. (zip -0r *)
== Photos ==
File:Gnome3_on_expresso10.jpeg|thumb|left|Gnome 3 on Samsung Galaxy Tab 2 10.1
== Links ==
* [ Device package]
* [ Kernel package]
Mainline kernel:
* WIP dts [ here]