Changes

Jump to navigation Jump to search
94 bytes removed ,  17:23, 10 December 2020
There are several ways to connect wires to a microUSB plug:
* solder the wires to a [https://www.sparkfun.com/products/10031 microUSB type B breakout board] (at the time of writing this is only available in backorder, perhaps we should increase the demand somewhat?)
* using a [https://www.adafruit.com/product/3972 USB Micro B Male Plug to 5-pin Terminal Block]
* solder the wires directly to a [https://www.adafruit.com/product/1826 microUSB type B plug] (note: the solder pads are very small, so it can be difficult to get just right. If you plan to use this method, order multiple plugs, in case you need to start over.)
364

edits

Navigation menu