Difference between revisions of "Xiaomi Mi Note 2 (xiaomi-scorpio)"
Jump to navigation
Jump to search
(Update OTG status) |
(→Mainline: Add touchkey status) |
||
Line 85: | Line 85: | ||
|Touchscreen | |Touchscreen | ||
| Y | | Y | ||
− | | | + | | |
+ | |- | ||
+ | |Touchkeys | ||
+ | |Y | ||
+ | |Driver not upstream yet. | ||
|- | |- | ||
|UFS | |UFS |
Revision as of 17:05, 24 February 2021
USB Networking |
Broken |
---|---|
Flashing |
Works |
Touchscreen |
Works |
Display |
Works |
WiFi |
Broken |
Xwayland | |
FDE | |
Mainline |
Works |
Battery |
Partial |
3D Acceleration |
Broken |
Accelerometer |
Broken |
Audio | |
Bluetooth | |
Camera | |
GPS | |
Mobile data | |
SMS | |
Calls | |
USB OTG | |
Contributors
- Tooniis
Maintainer(s)
- Tooniis
Users owning this device
- Tooniis (Notes: 64GB Storage, 4GB Memory)
How to enter flash mode
Hold Power + Volume Down while the phone is turned off. This will make the phone boot into fastboot mode
Installation
You will need to unlock the bootloader in order to be able to flash anything onto the phone.
Installing TWRP before doing anything else is recommended, as it makes dealing with the phone easier later on, and allows for quick restoration by taking backups of /system
and /boot
, then flashing them back in order to restore the device to its original state.
Mainline
Feature | Status | |
---|---|---|
USB | P | Peripheral mode only, host mode might be working but without power. USB networking works. |
Display | Y | Both simplefb and mdss work. |
Touchscreen | Y | |
Touchkeys | Y | Driver not upstream yet. |
UFS | Y | |
GPU | P | Somewhat glitchy, causes some artifacts and tearing on GNOME at least. |
WiFi | N | PCIe bus enabled but QCA6164A (QCA6174A??) doesn't show up. |
Bluetooth | Y | |
Buttons | Y | |
Battery | N | Will require fuel gauge and charger drivers |
LEDs | P | Keypad backlights only without brightness control. |
Audio | P | Headphones only. |
Sensors | N | |
Cameras | N | Will require drivers for both camera modules (IMX318 main, IMX268 front). |
NFC | Y | |
Modem | P | Sending and receiving SMS works. Haven't tested other things yet. |
Known issues:
- The display comes up blue after initialization sometimes. Rebooting makes it work usually.
- System locks up during heavy disk I/O loads.
See also
- pmaports!1576 Initial merge request
- Device package
- Kernel package