Xiaomi POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max
 Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse) with aftermarket display |
Manufacturer |
Xiaomi |
---|
Name |
POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max |
---|
Codename |
xiaomi-miatoll |
---|
Released |
2020 |
---|
Category |
testing |
---|
Original software |
Android 10, MIUI 11 |
---|
Hardware |
---|
Chipset |
Qualcomm SM7125 Snapdragon 720G |
---|
CPU |
Octa-core (2x2.3 GHz Kryo 465 Gold & 6x1.8 GHz Kryo 465 Silver) |
---|
GPU |
Adreno 618 |
---|
Display |
1080 x 2400 (IPS LCD, 6.67") |
---|
Storage |
64/128 GB |
---|
Memory |
6 GB |
---|
Architecture |
aarch64 |
---|
|
FeaturesUSB Networking |
|
---|
Flashing |
|
---|
Touchscreen |
|
---|
Display |
|
---|
WiFi |
|
---|
FDE |
|
---|
Mainline |
|
---|
Battery |
|
---|
3D Acceleration |
|
---|
Audio |
|
---|
Bluetooth |
|
---|
Camera |
|
---|
GPS |
|
---|
Mobile data |
|
---|
SMS |
|
---|
Calls |
|
---|
USB OTG |
|
---|
NFC |
|
---|
|
SensorsAccelerometer |
|
---|
Magnetometer |
|
---|
Ambient Light |
|
---|
Proximity |
|
---|
Hall Effect |
|
---|
Barometer |
|
---|
Power Sensor |
|
---|
|
MiscKeyboard |
|
---|
Touchpad |
|
---|
USB-A |
|
---|
HDMI/DP |
|
---|
Ir TX |
|
---|
TrustZone |
|
---|
FOSS bootloader |
|
---|
|
Contributors
Users owning this device
- Miki (Notes: daily driver, running Xiaomi.eu)
- Omame (Notes: daily driver)
- Selfisekai (Notes: daily driver, running Android)
- Somekool (Notes: Currently running PixysOS)
- Ungeskriptet (Notes: microG/Pokémon Go phone)
How to enter flash mode
- Fastboot: Power on the device with both Power and Volume Down buttons.
- Recovery: Power on the device with both Power and Volume Up buttons.
EDL Mode
 |
Note: An authenticated Mi account for EDL flashing is required. |
To enter the EDL mode, disconnect the battery and short these two points while powering it on with USB. If lsusb -d 05c6:9008
shows you a device, you can let go of the short.
UART
 |
Note: According to the schematics this is where UART should be, however there is no output on the TX point. Only 1.8V is being measured on TX. |
The UART points are located on the front on the mainboard, so thin wires should be soldered to the tiny test points to route them to the back.
Installation
/* Not yet */
See also