Xiaomi POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max (xiaomi-miatoll)

From postmarketOS
Revision as of 16:49, 14 April 2022 by Ungeskriptet (talk | contribs) (Mark mainline as partial)
Jump to navigation Jump to search
Xiaomi POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max
Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse) with aftermarket display
Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse) with aftermarket display
Manufacturer Xiaomi
Name POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max
Codename xiaomi-miatoll
Released 2020
Category testing
Original software Android 10, MIUI 11
Hardware
Chipset Qualcomm SM7125 Snapdragon 720G
CPU Octa-core (2x2.3 GHz Kryo 465 Gold & 6x1.8 GHz Kryo 465 Silver)
GPU Adreno 618
Display 1080 x 2400 (IPS LCD, 6.67")
Storage 64/128 GB
Memory 6 GB
Architecture aarch64
This device is marked as not booting.
Features
USB Networking
Flashing
Touchscreen
Display
WiFi
FDE
Mainline
Partial
Battery
3D Acceleration
Audio
Bluetooth
Camera
GPS
Mobile data
SMS
Calls
USB OTG
NFC
Sensors
Accelerometer
Magnetometer
Ambient Light
Proximity
Hall Effect
Barometer
Power Sensor
Misc
Camera Flash
Keyboard
Touchpad
USB-A
HDMI/DP
Ir TX
Ir RX
Stylus
Haptics
Ethernet
FOSS bootloader



Contributors

Users owning this device

  • Miki (Notes: daily driver, running Pixel Experience)
  • Omame (Notes: daily driver)
  • Projjal
  • Selfisekai (Notes: daily driver, running Android)
  • Somekool (Notes: Currently running PixysOS)
  • Ungeskriptet (Notes: Going to finish mainline someday...)

How to enter flash mode

  • Fastboot: Power on the device with both Power and Volume Down buttons.
  • Recovery: Power on the device with both Power and Volume Up buttons.

EDL Mode

Note Note: An authenticated Mi account for EDL flashing is required.

To enter the EDL mode, disconnect the battery and short these two points while powering it on with USB. If lsusb -d 05c6:9008 shows you a device, you can let go of the short.

Xiaomi-joyeuse edl-mode.png

UART

The UART points are located on the front on the mainboard, so thin wires should be soldered to the tiny test points to route them to the back.

Xiaomi-joyeuse UART.png

Installation

/* Not yet */

See also