Xiaomi POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max (xiaomi-miatoll)
(Redirected from Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse))
Jump to navigation
Jump to search
USB Networking |
Works |
---|---|
Flashing |
Works |
Touchscreen | |
Display |
Works |
WiFi |
Works |
Xwayland | |
FDE | |
Mainline |
Partial |
Battery | |
3D Acceleration | |
Audio | |
Bluetooth | |
Camera | |
GPS | |
Mobile data | |
SMS | |
Calls | |
USB OTG | |
NFC | |
Accelerometer | |
---|---|
Magnetometer | |
Ambient Light | |
Proximity | |
Hall Effect | |
Ir TX | |
---|---|
TrustZone | |
This device is based on Qualcomm Snapdragon 720G (SM7125). See the SoC page for common tips, guides and troubleshooting steps |
Contributors
Users owning this device
- Omame (Notes: daily driver, currently running Xiaomi.eu (Android 11, MIUI 12.5.3))
- Selfisekai (Notes: daily driver, running Android)
- Somekool (Notes: Currently running PixysOS)
- Ungeskriptet (Notes: Was totally borked (Although I think the UART logic is fired))
How to enter flash mode
- Fastboot: Power on the device with both Power and Volume Down buttons.
- Recovery: Power on the device with both Power and Volume Up buttons.
EDL Mode
![]() |
Note: An authenticated Mi account for EDL flashing is required. |
To enter the EDL mode, disconnect the battery and short these two points while powering it on with USB. If lsusb -d 05c6:9008
shows you a device, you can let go of the short.
UART
The UART points are located on the front on the mainboard, so thin wires should be soldered to the tiny test points to route them to the back.
Installation
/* Not yet */