Barnes & Noble Nook Simple Touch (barnesnoble-zoom2)
Appearance
| This device is marked as not booting. |
|
Nook Simple Touch, stock, with battery fully dead | |
| Manufacturer | Barnes & Noble |
|---|---|
| Name | Nook Simple Touch |
| Codename | zoom2 |
| Model | BNRV300 |
| Released | 2011 |
| Type | ebook reader |
| Hardware | |
| Chipset | TI OMAP 3621 |
| CPU | 1x 800 MHz Cortex-A8 |
| GPU | PowerVR SGX530 |
| Display | 6 in (152 mm), 600 x 800 pixel, 167 PPI, E Ink Pearl ED060SCE(LF)C1 |
| Storage | 2 GB |
| Memory | 256 MB |
| Architecture | armv7 |
| Software | |
Original software The software and version the device was shipped with. |
Android 2.1 |
Extended version The most recent supported version from the manufacturer. |
Android |
| postmarketOS | |
Pre-built images Whether pre-built images are available from the postmarketOS Installation page. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
| If "zoom2" isn't the correct codename, feel free to change it. |
Users owning this device
- Koshchki123 (Notes: On version 1.1)
- Pixelo789 (Notes: New (I got it sealed); battery dead)
Setting up and using ClockworkMod (CWM)
| WARNING: I have not tested these instructions; you are on your own. |
(Instructions are adapted from this XDA thread)
- Download a CWM image from this XDA thread.
- Flash the downloaded image to an SD card. Once done, extend the partition using whatever software.
- Open a file manager. At the root of the SD card, create a folder called "clockworkmod", and within it, a folder called "backup". This is used to create a backup and flash images.
Flashing an image
- Download an image, potentially one from the above thread.
- Copy the folder from the .zip to the "downloads/clockworkmod" folder on the CWM SD card.
- Eject the SD card from your computer.
- Make sure your battery is charged. The XDA thread recommends at least 60%.
- Turn off the device, insert the SD card, and turn it back on.
- To navigate CWM:
- Upper-left is previous menu
- Upper-right is up
- Lower-right is down
- "n" button is select
- Select "backup/restore", then "backup". When the device is done backing up, you will be returned to the main menu.
- Select "wipe data/factory reset", then confirm. If at any point CWM freezes, repeatedly press and hold the power button.
- Select "advanced", then "wipe dalvik cache", then confirm.
- Select "backup/restore", then "restore", then the name of the folder that you copied over, then confirm.
- Once done, remove the CWM card and select "reboot system now".
- Follow any other instructions described when downloading the image.
Installing postmarketOS
Not yet :(