FuriLabs FuriPhone FLX1 (krypton)
Appearance
| This device is still running on aarch64, although it supports armv7. If you own it, change it and test it that way. |
| This page is about the dedicated port of this device. There is also an optional generic port available for this device - see Generic MT6788 (mediatek-mt6788). |
| This device is unsupported by postmarketOS (most likely due to its architecture being unsupported, or limited system resources).
Reason: Mainline in works on ivoszbg/linux-next, fully supported by FuriOS (debian) |
| Manufacturer | FuriLabs |
|---|---|
| Name | Furiphone FLX1 |
| Codename | krypton |
| Released | 2024 |
| Type | handset |
| Hardware | |
| Chipset | MediaTek Dimensity 900 (MT6877) |
| CPU |
2x 2.4GHz Cortex-A78 6x 2GHz Cortex-A55 |
| GPU | Mali-G68 MC4 |
| Display | 6.59 inch 20:9, 1080 x 2412 FHD+, 10 point multi touch |
| Storage | 128 UFS2.1 |
| Memory | 6 GB LPDDR4X |
| Architecture | aarch64 |
| Write-Protect type | fused, allows unsigned |
| Software | |
Original software The software and version the device was shipped with. |
FuriOS 13.0.2 |
Extended version The most recent supported version from the manufacturer. |
FuriOS 12.1.1 (active development) |
| Optional software | Ubuntu Touch and SailfishOS |
| FOSS bootloader | no |
| postmarketOS | |
Pre-built images Whether pre-built images are available from the postmarketOS Installation page. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
pmOS kernel The kernel version that runs on the device's port. |
? |
Unixbench score Unixbench Whetstone/Dhrystone score. See Unixbench. |
886.7 |
| Optional Generic Port | Generic MT6788 (mediatek-mt6788) |
| This device is based on the Dimensity 900. See the SoC page for common tips, guides and troubleshooting steps |
| Note: Pending port to PostMarketOS |
Contributors
Users owning this device
Installation
TBD..