Jump to content

HMD Global Nokia 3.1 (nokia-ES2)

From postmarketOS Wiki
HMD Global Nokia 3.1
Nokia 3.1
Nokia 3.1
Manufacturer HMD Global
Name Nokia 3.1
Codename nokia-ES2
Released 2018
Type handset
Hardware
Chipset MediaTek Helio P15 (MT6750N)
CPU Octa-core 4x 1.5 GHz Cortex-A53
4x1.0 GHz Cortex-A53
GPU Mali-T860MP2
Display 720x1440 LCD
Storage 16 GB
Memory 2 GB
Architecture aarch64
Software
Original software
The software and version the device was shipped with.
Android 8.0
Extended version
The most recent supported version from the manufacturer.
Android 10
postmarketOS
Mainline
Instead of a Linux kernel fork, it is possible to run (Close to) Mainline.
no
pmOS kernel
The kernel version that runs on the device's port.
6.2-rc1
Features
Flashing
It is possible to flash the device with pmbootstrap flasher.
Works
USB Networking
After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system).
Broken
Battery
Charging and battery level reporting works
Untested
Screen
Display works. Ideally with sleep mode and brightness control.
Broken
Touchscreen
Untested
Multimedia
3D Acceleration
Untested
Audio
Audio playback, microphone, headset and buttons.
Untested
Camera
Untested
Connectivity
WiFi
Untested
Bluetooth
Untested
GPS
Untested
NFC
Near Field Communication
Untested
Modem
Calls
Untested
SMS
Untested
Mobile data
Untested
Miscellaneous
FDE
Full disk encryption and unlocking with unl0kr.
Untested
USB OTG
USB On-The-Go or USB-C Role switching
Untested
Sensors
Accelerometer
Auto screen rotation works in desktops e.g. Phosh or Plasma Mobile
Untested
Magnetometer
Sensor to measure magnetism
Untested
Ambient Light
Untested
Proximity
Untested

Contributors

Users owning this device


How to enter flash mode

Hold Power + Volume Down (while connected to the USB) to boot into the fastboot.

Installation

Mainline doesn't support mdsc, so boot only.

Mainline status

Mainline is very quirky and in very early state.

Booting

The booting works so far only through fastboot boot (don't know why) and only with an dummy dtbo.

UART Location