HMD Global Nokia 8 (nokia-NB1)
| This device is marked as not booting. |
| Manufacturer | HMD Global |
|---|---|
| Name | Nokia 8 |
| Codename | nokia-NB1 |
| Released | 2017 |
| Type | handset |
| Hardware | |
| Chipset | Qualcomm Snapdragon 835 (MSM8998) |
| CPU |
Octa-core (4x 2.45 GHz Kryo 280 4x 1.9 GHz Kryo 280) |
| GPU | 710 MHz Adreno 540 |
| Display | 5.3 inch 16:9, 1440x2560 60 Hz IPS LCD, 24 Bit (16777216 colors) |
| Storage | 64/128 GB UFS 2.1 + microSDXC + USB-C 3.1 |
| Memory | 4/6 GB 1866 MHz LPDDR4X dual-channel |
| Architecture | aarch64 |
| Software | |
Original software  The software and version the device was shipped with. |
Android 7.1.1 |
Extended version The most recent supported version from the manufacturer. |
Android 9 (on Linux 4.4) |
| Optional software | Android (LineageOS) |
| postmarketOS | |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
Unixbench score Unixbench Whetstone/Dhrystone score. See Unixbench. |
0.0 |
| This device is based on the Snapdragon 835. See the SoC page for common tips, guides and troubleshooting steps |
Contributors
Users owning this device
- Yuiyamu (Notes: runs lineageos, trying to port pmOS ^-^)
How to enter Download mode
While the device is completely powered off, hold volume down and plug in a USB cable. The device should then automatically enter download mode, and will then be able to respond to fastboot commands.
→
How to enter Recovery mode
While the device is completely powered off, hold volume up and plug in USB cable. The device should automatically start booting, and eventually get to a screen with an Android logo and the text "no command" underneath. Letting go of all buttons and unplugging the USB cable, you should then hold power and press volume up once to get to the Recovery mode screen.
→→→
Installation
Unlocking bootloader
See Unlocking Bootloaders/HMD_Global#MD5_Method
Using pmbootstrap
Follow Installation/Using pmbootstrap. When asked for the device's vendor/codename, select nokia as the vendor and ant as the codename.
To flash the image to the device:
- Enter flashing mode (see #How to enter flash mode)
- Continue with Installation/Using_pmbootstrap#Flashing