HTC Desire 820 Single SIM (htc-a51tuhl)
Manufacturer | HTC |
---|---|
Name | Desire 820 (Single SIM) |
Codename | htc-a51tuhl |
Released | 2014 |
Type | handset |
Hardware | |
Chipset | Qualcomm Snapdragon 615 (MSM8939) |
CPU | 4x 1.5GHz Cortex-A53 + 4x 1.0GHz Cortex-A53 |
GPU | Adreno 405 |
Display | 720x1280 SLCD |
Storage | 16 GB |
Memory | 2 GB |
Architecture | aarch64 |
Software | |
Original software | Android |
Original version | 4.4 |
postmarketOS | |
Category | testing |
Pre-built images | no |
Mainline | yes |
Contributors
Users owning this device
How to enter flash mode
In Power off state, use Volume- & power key to enter Hboot, and directly select the fastboot interface.
for fastboot boot requirement, need dts matched by following:
INFO[435302364] [DEBUG] Board pid:379, pcbid:0x80, soc version:0 INFOx10000
Seems this fastboot interface can't use general fastboot for flashing partition, need to use another method to flash. |
Installation
"The device must as S-OFF mode for installing custom kernel!"
For S-ON device, maybe recovery partition install lk2nd and boot to lk2nd can ignore the hboot limitation and can modify the system partition. (in recovery it'll always read-only.)
UART
Ground
You can connect to the ground by soldering to the pin shown in picture above or just using some part of the motherboard's ground plane, e.g. a screw hole or the large copper shielding.
TX
The picture above shows the motherboard's UART TX pin. Be aware that high level (logical 1) is 1.8 V.
Log
After holding power button down for 2 seconds, the motherboard transmits the following data:
Format: Log Type - Time(microsec) - Message - Optional Info Log Type: B - Since Boot(Power On Reset), D - Delta, S - Statistic S - QC_IMAGE_VERSION_STRING=BOOT.BF.3.0-00276 S - IMAGE_VARIANT_STRING=SAAAANAZA S - OEM_IMAGE_VERSION_STRING=jenkins.git.htc.com S - Boot Config, 0x000000e5 S - Core 0 Frequency, 0 MHz B - 1589 - PBL, Start B - 3621 - bootable_media_detect_entry, Start B - 781651 - bootable_media_detect_success, Start B - 781657 - elf_loader_entry, Start B - 782956 - auth_hash_seg_entry, Start B - 822238 - auth_hash_seg_exit, Start B - 844562 - elf_segs_hash_verify_entry, Start B - 930776 - PBL, End B - 938485 - SBL1, Start SBL1 abnormal reset magic = 0xffffffff [DEBUG][SBL1] sbl1_hw_init: PM device init B - 1008757 - pm_device_init, Start D - 14640 - pm_device_init, Delta [DEBUG][SBL1] sbl1_hw_init: Check device temperature [INFO][SBL1] sbl1_hw_init: SBL1 hw init done B - 1034194 - boot_flash_init, Start D - 0 - boot_flash_init, Delta [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra PID: 342, PCBID: 128 [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra Is ramdump: 0 [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra Security info: 3 [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra User Trial flag: 0 [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra JTAG disable flag: 1 [INFO][SBL1] sbl1_load_htc_extra: sbl1_load_htc_extra JTAG reenable flag: 0 [DEBUG][SBL1] sbl1_htc_init: radio_flag: 0x59EC9324, reset_reason: 0xD3D631DF B - 1120326 - boot_config_data_table_init, Start D - 30 - boot_config_data_table_init, Delta - (0 Bytes) B - 1130360 - CDT version:3,Platform ID:1,Major ID:1,Minor ID:0,Subtype:0 B - 1137040 - sbl1_ddr_set_params, Start B - 1143353 - cpr_init, Start D - 4361 - cpr_init, Delta B - 1147867 - Pre_DDR_clock_init, Start D - 274 - Pre_DDR_clock_init, Delta D - 0 - sbl1_ddr_set_params, Delta [SBL1] Detected DDR Info: interface 0 [SBL1] Manufacture_name: -16340474 [SBL1] CS0 Row/Col/Bank: 15/10/8 [SBL1] CS1 Row/Col/Bank: 15/10/8 [SBL1] Detected DDR Info: interface 1 [SBL1] Manufacture_name: 0 [SBL1] CS0 Row/Col/Bank: 0/0/0 [SBL1] CS1 Row/Col/Bank: 0/0/0 B - 1187853 - pm_driver_init, Start [INFO][SBL1][BATT] pm_chg_is_battery_weak: batt_vol: 3741mV, sbl_bootup_threshold: 3400mV, err: 0 D - 10797 - pm_driver_init, Delta B - 1212344 - clock_init, Start D - 122 - clock_init, Delta [INFO][SBL1] preserve_rpm_ram_data: Not in ramdump mode, skip to preserve RPM RAM [INFO][SBL1] preserve_smem_data: Not in ramdump mode, skip to preserve SHARE RAM [INFO][SBL1] preserve_qsee_code: Not in ramdump mode, skip to preserve QSEE CODE [INFO][SBL1] boot_config_process_entry: Loading QSEE... B - 1246077 - Image Load, Start [INFO][SBL1] boot_auth_image: Image 7 signature verify pass D - 54565 - QSEE Image Loaded, Delta - (506312 Bytes) [INFO][SBL1] security_set_emmc_write_protection: [security] s-on check [INFO][SBL1] set_power_on_write_protection: [security] write protect on B - 1321382 - Image Load, Start D - 61 - SEC Image Loaded, Delta - (0 Bytes) B - 1328671 - sbl1_efs_handle_cookies, Start D - 213 - sbl1_efs_handle_cookies, Delta [INFO][SBL1] boot_config_process_entry: Loading QHEE... B - 1342274 - Image Load, Start [INFO][SBL1] boot_auth_image: Image 21 signature verify pass D - 41602 - QHEE Image Loaded, Delta - (68336 Bytes) [INFO][SBL1] boot_config_process_entry: Loading RPM... B - 1390769 - Image Load, Start [INFO][SBL1] boot_auth_image: Image 10 signature verify pass D - 42609 - RPM Image Loaded, Delta - (156028 Bytes) [INFO][SBL1] boot_config_process_entry: Loading APPSBL... B - 1438014 - Image Load, Start [DEBUG][SBL1] boot_auth_image: PID: 342 [INFO][SBL1] boot_auth_image: SHIP RSA verify Success for type: 9 [INFO][SBL1] boot_auth_image: Image 9 signature verify pass D - 593377 - APPSBL Image Loaded, Delta - (2096384 Bytes) B - 2036790 - QSEE Execution, Start D - 91 - QSEE Execution, Delta B - 2043469 - SBL1, End D - 1107241 - SBL1, Delta S - Flash Throughput, 58000 KB/s (2854140 Bytes, 48403 us) S - DDR Frequency, 796 MHz security_level 3 jtag_disable_flag 1 jtag_reenable_flag 0 pid 342 pcbid 128 enter_boot_dload_flag 0 engineerid 0 fuse is blown TZ 3.02.A64.02 342-3-1-0-0 #P:ok
See also
- this device is named as Desire 820f (d820f), not d820s
- pmaports!1669 Initial (unmerged) mainline merge request
- Mainline kernel tree