HTV box HTV 3 (htv-box-htv-3)
Appearance
| This device is marked as not booting. |
|
About page of HTV box HTV 3 in stock android | |
| Manufacturer | HTV box |
|---|---|
| Name | HTV 3 |
| Codename | htv-box-htv-3 |
| Released | 20XX |
| Type | set-top box |
| Hardware | |
| Chipset | Amlogic S805 |
| CPU | 4x ARM Cortex-A5 @ 1.5 GHz |
| GPU | Mali-450 MP2 |
| Display | HDMI |
| Storage | 8GB |
| Memory | 1GB |
| Architecture | armv7 |
| Software | |
Original software The software and version the device was shipped with. |
Android 4.4.2 (Linux 3.10.33) |
Extended version The most recent supported version from the manufacturer. |
Android |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
Contributors
Users owning this device
- Exkc (Notes: Toy found in store)
Current State
Non-Booting Device
How to enter flash mode and how to connect to a pc
0. unplug the power
1. Connect this usb port to your pc via usb male a to usb male a.
| WARNING: Make sure the 5v vcc pin aint connected in the cable otherwise it might will burn when u plug the cable to it. |
2. Holding this button while u power it on and u r done.
Installation
UART
To get UART working, solder wires the points shown below . The baud rate is 115200.
Pictures
-
Front pcb of htv-box-htv-3
-
Back pcb of htv-box-htv-3