Lenovo A6010 (lenovo-a6010)

From postmarketOS Wiki
Note This page is about the dedicated port of this device. There is also an optional generic port available for this device - see Generic MSM8916 (qcom-msm8916).
Lenovo A6010
Manufacturer Lenovo
Name A6010
Codename lenovo-a6010
Released 2015
Type handset
Hardware
Chipset Qualcomm Snapdragon 410 (MSM8916)
CPU Quad-core 1.2 GHz Cortex-A53
GPU Adreno 306
Display 720x1280
Storage 8/16 GB
Memory 1/2 GB
Architecture aarch64
Software
Original software Android
Original version 5
postmarketOS
Category community
Pre-built images yes
Optional Generic Port Generic MSM8916 (qcom-msm8916)
Features
Flashing
Works
USB Networking
Works
Internal storage
SD card
Battery
Partial
Screen
Works
Touchscreen
Works
Multimedia
3D Acceleration
Works
Audio
Works
Camera
Camera Flash
Connectivity
WiFi
Works
Bluetooth
Works
GPS
Modem
Calls
Works
SMS
Works
Mobile data
Works
Miscellaneous
FDE
Works
USB OTG
Partial
Sensors
Accelerometer
Works
Magnetometer
Works
Ambient Light
Proximity
Hall Effect
Haptics
This device is based on the Snapdragon 410.
See the SoC page for common tips, guides and troubleshooting steps

Contributors

Users owning this device


How to enter flash mode

  • Fastboot: Power on the device with both Power and Volume Down buttons.
  • Recovery: Power on the device with Volume Down, Volume Up, and Power buttons.
  • lk2nd Fastboot: Power on the device. After it vibrates, hold Volume Down.
  • lk2nd Recovery: Power on the device. After it vibrates, hold Volume Up.
  • EDL: Connect device via USB as peripheral with both Volume Up and Volume Down buttons.

Installation

  1. Make sure that you have qimei-ili9881, yassy-ili9881 or tianma-hx8394d panel. Other panels aren't supported yet.
  2. Install lk2nd. Although Lenovo already provides a Fastboot interface, lk2nd contains various quirks for booting mainline.
    • use fastboot flash:raw boot lk2nd-msm8916.img
  3. Follow Qualcomm_Snapdragon_410/412_(MSM8916)#Installation.

Battery

Lenovo A6010 uses VM-BMS to measure battery status and FAN54015 charger. Battery status works. It is inaccurate, but you will know when you need to reboot into recovery and charge the device. Charging is not supported yet.

Mobile data

The default mode is 2G only, you will probably want to change it (Phosh Settings > Mobile Network > Network Mode). You will also have to set up APN (Phosh Settings > Mobile Network > Access Point Names).

USB OTG

Works with external power.

Leds

Enabling green:

$ echo 1 | sudo tee /sys/class/leds/green/brightness

Disabling green:

$ echo 0 | sudo tee /sys/class/leds/green/brightness

Enabling red:

$ echo 1 | sudo tee /sys/class/leds/red/brightness

Disabling red:

$ echo 0 | sudo tee /sys/class/leds/red/brightness

See also