Prestigio MultiPad PMT5008 3G (prestigio-pmt5008-3g)

From postmarketOS
Prestigio Prestigio MultiPad PMT5008 3G
File:CHANGE ME TO DEVICE CODENAME.jpg
CHANGE_ME
Manufacturer Prestigio
Name Prestigio MultiPad PMT5008 3G
Codename prestigio-pmt5008-3g
Released 2016
Category testing
Pre-built images no
Original software Android
Original version 4.4
Hardware
Chipset MediaTek MT8382
CPU 4x1.3 GHz Cortex A7
GPU Mali-400 MP2
Display 1280x800 IPS
Storage 8 GB
Memory 1 GB
Architecture ARMv7
This device is marked as not booting.
Status: No kernel sources, but mainline starts up and serial console works
Features
USB Networking
Flashing
Touchscreen
Display
WiFi
FDE
Mainline
Partial
Battery
3D Acceleration
Audio
Bluetooth
Camera
GPS
Mobile data
Internal storage
SMS
Calls
USB OTG
NFC
Sensors
Accelerometer
Magnetometer
Ambient Light
Proximity
Hall Effect
Barometer
Power Sensor
Misc
Built-in DVB
Camera Flash
Keyboard
Touchpad
USB-A
HDMI/DP
Ir TX
Ir RX
Stylus
Memory Card
Haptics
Ethernet
FOSS bootloader
This device is based on the MediaTek MT6582.
See the SoC page for common tips, guides and troubleshooting steps

Contributors

  • km2

Users owning this device

  • Km2 (Notes: I'm trying to port mainline)


How to enter flash mode

Installation

Mainline Kernel Status

There is no downstream kernel source code for this device. So I decided to port mainline linux and I was pretty quick to successfully start 4 uart ports, wdt, smp and /bin/sh from initramfs. But for further progress, you need to write the pinctrl and clk drivers.

Also this device uses pmic mt6323 which seems to be in mainline.

See also