SQFMI Beepy (sqfmi-beepy)
Appearance
| This device is supported as part of a generic port. Refer to raspberry-pi02 for installation instructions and more information. |
| This device has been tested with postmarketOS, but its device package has not yet been added to the postmarketOS repositories. This means that it cannot be selected in pmbootstrap. Status: everything works |
|
SQFMI beepy running Alpine Linux | |
| Manufacturer | SQFMI |
|---|---|
| Name | Beepy |
| Codename | sqfmi-beepy |
| Model | beepy |
| Released | CHANGE_ME |
| Type | handset |
| Hardware | |
| Chipset | RP3A0 |
| CPU | BCM2710A1 |
| GPU | BCM2710A1 |
| System-on-Module | Raspberry Pi Zero 2 |
| Display | 400x240 |
| Storage | sdcard |
| Memory | 512M |
| Architecture | aarch64 |
| Software | |
Original software The software and version the device was shipped with. |
Debian 10 |
Extended version The most recent supported version from the manufacturer. |
Debian 12 |
| FOSS bootloader | yes |
| postmarketOS | |
| Category | testing |
Pre-built images Whether pre-built images are available from the postmarketOS Installation page. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
yes |
pmOS kernel The kernel version that runs on the device's port. |
6.12 (linux-rpi from alpine) |
Unixbench score Unixbench Whetstone/Dhrystone score. See Unixbench. |
0.0 |
| Generic port | raspberry-pi02 |
| Firmware package | firmware-sqfmi-beepy |
Initial MR Initial merge request. |
7296 |
Flashing Whether it is possible to flash the device with pmbootstrap flasher. |
Works
|
|---|---|
USB Networking After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system). |
Works
|
SD card Also includes other external storage cards. |
Works
|
Battery Whether charging and battery level reporting work. |
Works
|
Screen Whether the display works; ideally with sleep mode and brightness control. |
Works
|
Keyboard Whether the built-in physical keyboard works. |
Works
|
Touchpad Whether the built-in touchpad works. |
Works
|
| Connectivity | |
WiFi |
Works
|
Bluetooth |
Works
|
| Miscellaneous | |
FDE Full disk encryption and unlocking with unl0kr. |
Works
|
SATA/eSATA |
Untested
|
USB OTG USB On-The-Go or USB-C Role switching. |
Works
|
HDMI/DP Video and audio output with HDMI or DisplayPort. |
Works
|
| Sensors | |
Power Sensor Sensor to monitor current, voltage and power. Not fuel gauge! |
Works
|
Contributors
Users owning this device
- Elagost (Notes: porting!)
How to enter flash mode
| Add step-by-step instructions for enabling flash mode. |
Installation
Using pmbootstrap
This is just a raspberry pi, so flash the SD card as normal: pmbootstrap install --sdcard=/dev/mmcblkX