Sony Bravia KDL-48R550C (sony-bravia550c)
Appearance
| This device is marked as not booting. Status: can't get uart yet |
|
CHANGE_ME CHANGE_ME | |
| Manufacturer | Sony |
|---|---|
| Name | Bravia Internet TV |
| Codename | sony-bravia550c |
| Model | KDL-48R550C |
| Released | 2015 |
| Type | change_me |
| Hardware | |
| Chipset | MediaTek MT5565 |
| CPU | CHANGE_ME |
| GPU | CHANGE_ME |
| Display | 1920 x 1080 IPS |
| Storage | 512 MB NAND |
| Memory | 512 MB DDR3 |
| Architecture | armv7 |
| Software | |
Original software The software and version the device was shipped with. |
Proprietary Linux-based software |
Extended version The most recent supported version from the manufacturer. |
Proprietary Linux-based software |
| postmarketOS | |
Pre-built images Whether pre-built images are available from the postmarketOS Installation page. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
no |
pmOS kernel The kernel version that runs on the device's port. |
6.x.x |
Unixbench score Unixbench Whetstone/Dhrystone score. See Unixbench. |
0.0 |
Users owning this device
How to enter flash mode
| Add step-by-step instructions for enabling flash mode. |
Parts table
| Type | Vendor | Model |
|---|---|---|
| Storage | Kioxia | TC58NVG2S0HBAI4 (4Gbit / 512MB) |
| LED Driver | ROHM | BD9397EFV |
| USB Hub | Genesys Logic | GL850G |
| Bus Switch | OnSemi | NLAS7242 |
| Sound Amplifier (HP) | Texas Instruments | TPA6138A2 |
| Sound Amplifier (SPK) | ROHM | BD28620 |
UART
UART is muxed to the USB1 port. Same UART as 4 pins header next to the headphone jack.
Unfortunately, the UART only this message and nothing else:
"CEC_Init:set cec pin to cec function!!"
Board images