Xiaomi Mi Max 2 (xiaomi-oxygen)
(Redirected from Xiaomi Mi Max 2)
 |
This device is supported as part of a generic port. Refer to Generic MSM8953 (qcom-msm8953) for installation instructions and more information. |
 | |
| Manufacturer | Xiaomi |
|---|---|
| Name | Mi Max 2 |
| Codename | xiaomi-oxygen |
| Released | 2017 |
| Type | handset |
| Hardware | |
| Chipset | Qualcomm Snapdragon 625 (MSM8953) |
| CPU | Octa-core 2.0 GHz Cortex-A53 |
| GPU | Adreno 506 |
| Display | 1080 x 1920 IPS LCD |
| Storage | 32/64 GB |
| Memory | 4 GB |
| Architecture | aarch64 |
| Software | |
Original software  The software and version the device was shipped with. |
Android 7.1.1 |
Extended version The most recent supported version from the manufacturer. |
Android |
| FOSS bootloader | yes |
| postmarketOS | |
| Category | community |
Pre-built images Whether pre-built images are available from the postmarketOS Installation page. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
yes |
pmOS kernel The kernel version that runs on the device's port. |
7.0.9 |
| Generic port | Generic MSM8953 (qcom-msm8953) |
| Device package |
 device-qcom-msm8953 |
| Kernel package |
linux-postmarketos-qcom-msm8953 |
Initial MR Initial merge request. |
pmaports!6510 |
Flashing Whether it is possible to flash the device with pmbootstrap flasher. |
Works
|
|---|---|
USB Networking After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system). |
Works
|
Battery Whether charging and battery level reporting work. |
Works
|
Screen Whether the display works; ideally with sleep mode and brightness control. |
Works
|
Touchscreen |
Works
|
| Multimedia | |
Audio Audio playback, microphone, headset and buttons. |
Broken
|
Camera |
Broken
|
Camera Flash |
Broken
|
| Connectivity | |
WiFi |
Works
|
Bluetooth |
Works
|
GPS |
Partial
|
| Modem | |
Calls |
Broken
|
SMS |
Broken
|
Mobile data |
Broken
|
| This device is based on the Qualcomm Snapdragon 450 (MSM8953). See the SoC page for common tips, guides and troubleshooting steps |
Installation
- Follow the Installation guide
|
Note: lk2nd is a hard dependency, without it the mainline kernel will not select the panel. |
$ pmbootstrap init # choose Vendor: qcom Device codename: msm8953
$ pmbootstrap install
$ pmbootstrap flasher flash_lk2nd
$ pmbootstrap flasher flash_rootfs
How to enter flash mode
|
Note: Pressing the keys too early will cause the stock bootloader to handle the key combination. You will end up in the wrong Fastboot interface. |
- Stock Fastboot: Power on the device with both and buttons
- lk2nd Fastboot: Power on the device. After it vibrates, hold
- Recovery: Power on the device with both and buttons