HTC Wildfire (htc-buzz): Difference between revisions
Appearance
m Eloy moved page HTC Buzz (htc-buzz) to HTC Wildfire (htc-buzz): fix name |
m Update codename, use Button template |
||
Line 3: | Line 3: | ||
| manufacturer = HTC | | manufacturer = HTC | ||
| name = Wildfire | | name = Wildfire | ||
| codename = buzz | | codename = htc-buzz | ||
| imagecaption = HTC Wildfire | | imagecaption = HTC Wildfire | ||
| releaseyear = 2010 | | releaseyear = 2010 | ||
Line 49: | Line 49: | ||
== How to enter flash mode == | == How to enter flash mode == | ||
Hold the | Hold the {{Button|Volume Down}} button, and then press the {{Button|Power}} button. Choose FASTBOOT. | ||
== Installation == | == Installation == |
Revision as of 15:53, 1 April 2020
Unfortunately this device doesn't have an FPU, so it doesn't work with Alpine's armhf architecture. |
WARNING: This device is not recommended for future use with postmarketOS due to its armhf architecture. Alpine Linux (the distribution that postmarketOS extends) pmaports#599 has been considering dropping it. The processor of the device may support the armv7 architecture. If so, you can modify the device package and change the architecture accordingly. |
This device is marked as not booting.
Status: Kernel compiles. But ARMv6 devices without FPU are not supported by Alpine's armhf
Status: Kernel compiles. But ARMv6 devices without FPU are not supported by Alpine's armhf
Manufacturer | HTC |
---|---|
Name | Wildfire |
Codename | htc-buzz |
Released | 2010 |
Hardware | |
Chipset | Qualcomm MSM7225 Snapdragon S1 |
CPU | 528 MHz ARM 11 |
GPU | No |
Display | 240x320 |
Storage | 512 MB |
Memory | 384 MB |
Architecture | armhf |
Software | |
Original software | Android 2.1 |
postmarketOS | |
Category | testing |
Pre-built images | no |
Contributors
- feinerer
Maintainer(s)
- feinerer
What works
- Kernel compilation
What does not work
- Everything else
How to enter flash mode
Hold the
button, and then press the button. Choose FASTBOOT.Installation
Flashing the partitions does not work yet, so you will need an SD card. |
- Install everything using an SD card
pmbootstrap install --sdcard=/dev/sd?
- Insert the SD-Card on the device
- Enter flash mode
- Boot kernel using
pmbootstrap flasher boot
See also
- #1203 HTC Wildfire status report