Samsung Galaxy SL (samsung-i9003)
Appearance
WARNING: This device is not recommended for future use with postmarketOS due to its armhf architecture. Alpine Linux (the distribution that postmarketOS extends) pmaports#599 has been considering dropping it. The processor of the device may support the armv7 architecture. If so, you can modify the device package and change the architecture accordingly. |
![]() Samsung Galaxy SL | |
Manufacturer | Samsung |
---|---|
Name | Galaxy SL |
Codename | samsung-i9003 |
Released | 2011 |
Hardware | |
Chipset | TI OMAP 3630 |
CPU | 1.0 GHz Cortex-A8 |
GPU | PowerVR SGX530 |
Display | 480x800 |
Storage | 4/16 GB |
Memory | 478 MB |
Architecture | armhf |
Software | |
Original software | Android 2.2 (Froyo), 2.3 (Gingerbread) |
postmarketOS | |
Category | testing |
Pre-built images | no |
Flashing |
Partial |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
No data |
Screen |
Works |
Touchscreen |
Works |
Multimedia | |
3D Acceleration |
No data |
Audio |
Partial |
Camera |
No data |
Camera Flash |
No data |
Connectivity | |
WiFi |
Works |
Bluetooth |
No data |
GPS |
No data |
NFC |
No data |
Modem | |
Calls |
No data |
SMS |
No data |
Mobile data |
No data |
Miscellaneous | |
FDE |
Partial |
USB OTG |
No data |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
No data |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
- dakk
Users owning this device
- Alter0ne
- Danfigasystems (Notes: 4GB model. Screen in scratches)
- Vipaol (Notes: Stock)
Installation
Use pmbootstrap install --sdcard=/dev/sdX to perform an SD card install (install to MTD /system may not work). Also, use `pmbootstrap flasher flash_kernel` to flash the initfs using Heimdall (ensure your device is in Download mode VolDown + Home + Power)
Wi-Fi
This device has a wl1271 chip from TI. To use it, you need to install a non-free firmware linux-firmware-ti-connectivity
apk add linux-firmware-ti-connectivity
modprobe -r wl12xx_sdio && modprobe wl12xx_sdio ifconfig wlan0 up iw wlan0 set type managed wpa_supplicant -u -Dnl80211 -B -c /etc/wpa_supplicant/wpa_supplicant.conf -iwlan0 udhcpc -b -i wlan0
Display
To adjust brightness:
# # Replace $VAL with a value from 0 to 255: # echo $VAL > /sys/class/backlight/omap_bl/brightness
Keyboard Backlight
To enable, and turn off the keyboard backlight, insert instead of $ VAL 0 or 1: echo $VAL >> /sys/class/leds/button-backlight/brightness
Device info
Links
Photos
- postmarketOS running