Samsung Galaxy S10 (samsung-beyond1lte)
Appearance
Samsung Galaxy S10 Samsung Galaxy S10 | |
Manufacturer | Samsung |
---|---|
Name | Galaxy S10 |
Codename | samsung-beyond1lte |
Released | 2019 |
Hardware | |
Chipset | Exynos 9820 |
CPU |
Octa-core Exynos M4 & Cortex-A75 & Cortex-A55 2 x 2.73 GHz + 2x 2.31 + 4 x 1.95 GHz |
GPU | Mali-G76 MP12 |
Display | 3040x1440 Dynamic AMOLED |
Storage | 128 / 512 GB |
Memory | 8 GB |
Architecture | aarch64 |
Software | |
Original software | Android 9.0 up to Android 11.0 |
postmarketOS | |
Category | testing |
Pre-built images | no |
Mainline | no |
Flashing |
Works |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
Works |
Screen |
Partial |
Touchscreen |
Works |
Multimedia | |
3D Acceleration |
Broken |
Audio |
Broken |
Camera |
Broken |
Camera Flash |
No data |
IR TX |
No data |
Connectivity | |
WiFi |
Works |
Bluetooth |
Broken |
GPS |
Broken |
NFC |
Broken |
Modem | |
Calls |
Broken |
SMS |
Broken |
Mobile data |
Broken |
Miscellaneous | |
FDE |
Broken |
USB OTG |
Works |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
Broken |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
- Linux4
Users owning this device
- Lachtan999
- Linux4
- M2m (Notes: Samsung boot loop issue)
- Misopog (Notes: Like new, stock, daily driver)
- TPJS (Notes: Screen is heavily flickering)
How to enter flash mode
- Bootloder/ODIN mode: Connect the phone to a computer over USB cable. Right after that, hold
Volume Down
andBixby
buttons. Then clickVolume Up
to confirm. - Recovery: Connect the phone to a computer over USB cable. Right after that, hold
Power
,Volume Up
andBixby
buttons.
Installation
See also
- pmaports!2739 Initial merge request
- LineageOS wiki page