Jump to content

Xiaomi POCO M2 Pro / Redmi Note 9S / Redmi Note 9 Pro / Redmi Note 9 Pro Max / Redmi Note 10 Lite (xiaomi-miatoll)

From postmarketOS Wiki
Revision as of 19:14, 16 March 2022 by Ungeskriptet (talk | contribs) (UART: remove note because my phone is probably just broken)
This device is marked as not booting.
Xiaomi POCO M2 Pro /
Redmi Note 9S /
Redmi Note 9 Pro /
Redmi Note 9 Pro Max
Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse) with aftermarket display
Xiaomi Redmi Note 9 Pro (xiaomi-joyeuse) with aftermarket display
Manufacturer Xiaomi
Name POCO M2 Pro /
Redmi Note 9S /
Redmi Note 9 Pro /
Redmi Note 9 Pro Max
Codename xiaomi-miatoll
Released 2020
Hardware
Chipset Qualcomm SM7125 Snapdragon 720G
CPU Octa-core (2x2.3 GHz Kryo 465 Gold & 6x1.8 GHz Kryo 465 Silver)
GPU Adreno 618
Display 1080 x 2400 (IPS LCD, 6.67")
Storage 64/128 GB
Memory 6 GB
Architecture aarch64
Software
Original software Android 10, MIUI 11
postmarketOS
Category testing
Pre-built images no


Contributors

Users owning this device

How to enter flash mode

  • Fastboot: Power on the device with both Power and Volume Down buttons.
  • Recovery: Power on the device with both Power and Volume Up buttons.

EDL Mode

Note Note: An authenticated Mi account for EDL flashing is required.

To enter the EDL mode, disconnect the battery and short these two points while powering it on with USB. If lsusb -d 05c6:9008 shows you a device, you can let go of the short.

UART

The UART points are located on the front on the mainboard, so thin wires should be soldered to the tiny test points to route them to the back.

Installation

/* Not yet */

See also