Samsung Galaxy S Relay 4G (samsung-apexq)
Appearance
WARNING: This device is not recommended for future use with postmarketOS due to its armhf architecture. Alpine Linux (the distribution that postmarketOS extends) pmaports#599 has been considering dropping it. The processor of the device may support the armv7 architecture. If so, you can modify the device package and change the architecture accordingly. |
Samsung Galaxy S Relay 4G Samsung Galaxy S Relay 4G | |
Manufacturer | Samsung |
---|---|
Name | Galaxy S Relay 4G |
Codename | samsung-t699 |
Released | 2012 |
Hardware | |
Chipset | Qualcomm Snapdragon S4 |
CPU | 1.5 GHz dual-core Krait |
GPU | Adreno 225 |
Display | 480x800 Super AMOLED |
Storage | 8 GB |
Memory | 1 GB |
Architecture | armhf |
Software | |
Original software | Android 4.0.4 ICS |
postmarketOS | |
Category | testing |
Pre-built images | no |
Flashing |
No data |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
No data |
Screen |
Works |
Touchscreen |
No data |
Multimedia | |
3D Acceleration |
No data |
Audio |
No data |
Camera |
No data |
Camera Flash |
No data |
Connectivity | |
WiFi |
No data |
Bluetooth |
No data |
GPS |
No data |
NFC |
No data |
Modem | |
Calls |
No data |
SMS |
No data |
Mobile data |
No data |
Miscellaneous | |
FDE |
No data |
USB OTG |
No data |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
No data |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Status: Boots to splash screen, telnet available via usb initramfs debug
Contributors
- silver
Maintainer(s)
- silver
How to enter flash mode
- Hold power + Home + volume down
- When prompted, release all buttons and press volume up
Installation
Set phone to ODIN mode
1. Turn off phone 2. Connect USB cable 3. Hold VOLUME_DOWN + HOME + POWER until you get Warning!! screen 4. Push VOLUME_UP to continue to ODIN mode screen
Port information
- kernel android_kernel_samsung_d2
- commit 87f5fcaf7afef878914c3fcca2c2fd395f285902
- defconfig LineageOS/android_kernel_samsung_d2/87f5fcaf7afef878914c3fcca2c2fd395f285902/arch/arm/configs/cyanogen_apexq_defconfig
- boot.img from cm backup March 2017
Build tweaks
Just needed xz in makedepends and the partition defined for the kernel set to "BOOT". Then flashing works.
hello world
Linux (none) 3.4.103-cyanogenmod #1-postmarketOS SMP PREEMPT Mon Mar 4 23:03:30 UTC 2019 armv7l Linux