Samsung Galaxy Tab 3 8.0 (samsung-lt01)
WARNING: This device is not recommended for future use with postmarketOS due to its armhf architecture. Alpine Linux (the distribution that postmarketOS extends) pmaports#599 has been considering dropping it. The processor of the device may support the armv7 architecture. If so, you can modify the device package and change the architecture accordingly. |
![]() lt01wifi | |
Manufacturer | Samsung |
---|---|
Name | Galaxy Tab 3 8.0 |
Codename | samsung-lt01wifi |
Released | 2013 |
Hardware | |
Chipset | Exynos 4212 Dual |
CPU | Dual-core 1.5 GHz Cortex-A9 |
GPU | Mali-400MP4 |
Display | 800x1280 |
Storage | 16GB |
Memory | 1.5GB |
Architecture | armhf |
Software | |
Original software | Android 4.2.2 (Jelly Bean) |
postmarketOS | |
Category | testing |
Pre-built images | no |
Flashing |
Works |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
Works |
Screen |
Works |
Touchscreen |
Works |
Multimedia | |
3D Acceleration |
No data |
Audio |
Broken |
Camera |
Broken |
Camera Flash |
No data |
Connectivity | |
WiFi |
Broken |
Bluetooth |
Broken |
GPS |
No data |
NFC |
No data |
Miscellaneous | |
FDE |
No data |
USB OTG |
Broken |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
No data |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
knuxfanwin8
Maintainer(s)
knuxfanwin8
How to enter flash mode
Download mode: VolDown while powering on
Recovery mode: VolUp while powering on
Installation
Flash the system with pmbootstrap flasher flash_rootfs.
Links
Device (common):
https://github.com/gr8nole/android_device_samsung_lt01-common
Device (lt01wifi):
https://github.com/gr8nole/android_device_samsung_lt01wifi
Kernel:
https://github.com/gr8nole/android_kernel_samsung_smdk4x12
Proprietary:
https://github.com/gr8nole/proprietary_vendor_samsung
Notes/To Do
Required workaround: Add xz to makedepend to avoid lzma errors.
Only lt01wifi/T310 has been tested so far. I might make builds for T311 and T315 once I get T310 working.
XFCE ONLY:The device indicates when it's charging, but the actual batery percentage readings don't work.
USB OTG doesn't work (at least with my keyboard). Turned on OTG via kernel config and it still doesn't work (at least with the two keyboard I have).
Hardware buttons don't work yet. Hardware buttons do work, they just require triggerhappy. Back and menu buttons are in /dev/input/event1, home, volume and power buttons are in /dev/input/event0.
WiFi doesn't work (in fact, WiFi doesn't seem to appear in `ip a` at all!) WiFi should work using the i9070 method. Not much modifications are needed. Sadly, I can't figure out how to build the kernel module :/
Bluetooth doesn't work.
For more information about the build process, see https://mastodon.social/@knuxfanwin8/101699225884881827