Jump to content

Samsung Galaxy Ace 3 3G (samsung-logan)

From postmarketOS Wiki
Revision as of 14:47, 12 April 2025 by HenriDellal (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Note Not to be confused with the LTE model, which has a Qualcomm SoC! (If you have a letter after the model number, you have the LTE model.)
This device has been tested with postmarketOS, but its device package has not yet been added to the postmarketOS repositories.
This means that it cannot be selected in pmbootstrap.
Samsung Galaxy Ace 3 3G
GT-S7270 running Firefox under Xfce4
GT-S7270 running Firefox under Xfce4
Manufacturer Samsung
Name Galaxy Ace 3 3G
Codename samsung-logan
Released 2013
Type handset
Hardware
Chipset Broadcom BCM21664
CPU 1.0 GHz Cortex-A9
GPU VideoCore IV
Display 480x800 TFT
Storage 4 GB
Memory 1 GB
Architecture armv7
Software
Original software Android
Original version 4.2.2 (Jelly Bean)
FOSS bootloader no
postmarketOS
Category testing
Pre-built images no
Mainline -
postmarketOS kernel 3.4.5
Features
Flashing
Works
USB Networking
Works
Internal storage
No data
SD card
No data
Battery
Partial
Screen
Works
Touchscreen
Works
Multimedia
3D Acceleration
No data
Audio
Broken
Camera
Broken
Camera Flash
No data
Connectivity
WiFi
Broken
Bluetooth
Broken
GPS
Broken
Modem
Calls
No data
SMS
No data
Mobile data
No data
Miscellaneous
FDE
No data
USB OTG
No data
Sensors
Accelerometer
No data
Magnetometer
No data
Ambient Light
No data
Proximity
No data
Hall Effect
No data
Haptics
No data
Barometer
No data
Power Sensor
No data

Contributors

Users owning this device

How to enter flash mode

  • Download mode: While the device is turned off, hold Power + Home + Volume Down, and confirm the action by pressing Volume Up thereafter.
  • Recovery mode: While the device is turned off, hold Power + Home + Volume Up.

Installation

pmbootstrap init # Choose samsung-logan
pmbootstrap install
# Boot into download mode before running the command below
pmbootstrap flasher flash_rootfs
# Boot into download mode again
pmbootstrap flasher flash_kernel

Hardware Acceleration

Note Note: This is not fully tested and could not work.
  1. Open aports/device/testing/device-samsung-logan/APKBUILD in a text editor and add mesa-egl to the depends
  2. Rebuild the device package: pmbootstrap build device-samsung-logan --force
  3. Run pmbootstrap install --fde

However, the image will be much bigger than the system partition, so you will need to either flash it to another partition or an SD card.

USB Internet

See USB Internet.

Display

If your device is stuck on the postmarketOS splash screen on startup (or the screen is black) and you are using LightDM, connect to your phone via SSH and run this command:

loginctl show-seat seat0

If CanGraphical is no or 0, open the LightDM config in a text editor:

sudo vi /etc/lightdm/lightdm.conf

Find the line where it says #logind-check-graphical=true and replace it with logind-check-graphical=false. Restart the device and it now should work.

See also

  • pmaports!3779 Initial merge request (Not merged at the time of writing)