Amediatech X96 air (amediatech-x96-air)
Appearance
This device has been tested with postmarketOS, but its device package has not yet been added to the postmarketOS repositories.
This means that it cannot be selected in pmbootstrap.
This means that it cannot be selected in pmbootstrap.
Manufacturer | Amediatech |
---|---|
Name | x96 Air |
Codename | amediatech-x96-air |
Released | 2019 |
Type | set-top box |
Hardware | |
Chipset | Amlogic S905X3 |
CPU | Quad-core 2 GHz Cortex-A55 |
GPU | Mali-G31 |
Display | HDMI |
Storage | 16GB/32GB/64GB |
Memory | 2GB/4GB |
Architecture | aarch64 |
Software | |
Original software | Android |
Original version The version the device was shipped with. |
9 |
FOSS bootloader | partial |
postmarketOS | |
Category | testing |
Pre-built images Whether pre-built images are available here. |
no |
Mainline Instead of a Linux kernel fork, it is possible to run (Close to) Mainline. |
yes |
Flashing It is possible to flash the device with pmbootstrap flasher . |
Untested
|
---|---|
USB Networking After connecting the device with USB to your PC, you can connect to it via telnet (initramfs) or SSH (booted system). |
Untested
|
Screen Display works. Ideally with sleep mode and brightness control. |
Works
|
Multimedia | |
3D Acceleration |
Works
|
Audio Audio playback, microphone, headset and buttons. |
Broken
|
IR TX |
Untested
|
Connectivity | |
WiFi |
Broken
|
Bluetooth |
Broken
|
Miscellaneous | |
FDE Full disk encryption and unlocking with unl0kr. |
Untested
|
USB-A Full-sized USB-A port works (Usually applicable to SBCs and laptops). |
Works
|
USB OTG USB On-The-Go or USB-C Role switching |
Untested
|
HDMI/DP Video and audio output with HDMI or Display Port works. |
Works
|
Sensors | |
Power Sensor Sensor to monitor current, voltage and power. Not fuel gauge! |
Untested
|
Contributors
- Petr Hodina
Users owning this device
Summary
This device is nearly identical to the X96 Max Plus.
The main difference is additional USB 2.0 port on the device.
There are 2 variants:
- 100M LAN
- 1Gbit LAN
Installation
Use pmbootstrap to build your own installation image.
$ pmbootstrap init
$ pmbootstrap install --fde
See also
- pmaports!4108 Initial merge request