LG L70 (lg-w5)
Appearance
WARNING: This device is not recommended for future use with postmarketOS due to its armhf architecture. Alpine Linux (the distribution that postmarketOS extends) pmaports#599 has been considering dropping it. The processor of the device may support the armv7 architecture. If so, you can modify the device package and change the architecture accordingly. |
Manufacturer | LG |
---|---|
Name | L70 |
Codename | lg-w5 |
Released | 2014 |
Hardware | |
Chipset | Qualcomm MSM8210 Snapdragon 200 |
CPU | Dual-core 1.2 GHz Cortex-A7 |
GPU | Adreno 302 |
Display | 480 x 800 IPS LCD |
Storage | 4 GB |
Memory | 1 GB |
Architecture | armhf |
Software | |
Original software | Android 4.4.2 (KitKat) |
postmarketOS | |
Category | testing |
Pre-built images | no |
Flashing |
No data |
---|---|
USB Networking |
Works |
Internal storage |
No data |
SD card |
No data |
Battery |
No data |
Screen |
No data |
Touchscreen |
No data |
Multimedia | |
3D Acceleration |
No data |
Audio |
No data |
Camera |
No data |
Camera Flash |
No data |
Connectivity | |
WiFi |
No data |
Bluetooth |
No data |
GPS |
No data |
NFC |
No data |
Modem | |
Calls |
No data |
SMS |
No data |
Mobile data |
No data |
Miscellaneous | |
FDE |
No data |
USB OTG |
No data |
HDMI/DP |
No data |
Sensors | |
Accelerometer |
No data |
Magnetometer |
No data |
Ambient Light |
No data |
Proximity |
No data |
Hall Effect |
No data |
Haptics |
No data |
Barometer |
No data |
Contributors
- Paakke
Installation
At the moment flashing is not working, so it is necessary to install to sdcard and then live boot from fastboot.
Installing to sdcard works with the command
# Replace /dev/sdX with the device for your sdcard
$ pmbootstrap install --sdcard /dev/sdX
Now place the sdcard into the phone. Assuming that the bootloader is unlocked, it is possible to get to fastboot by following steps
- Disconnect and reconnect the battery.
- Hold volume up while connecting phone to computer with a usb cable.
Now it is possible to live boot.
$ pmbootstrap flasher boot
The screen doesn't work yet, so for now the only way to find out if it booted is by usb networking or the maximum attention hook.